Audio Database

SL-110
Commentary

An armless player system composed of SL-1100 without the tone arm.

A DC motor with ultra-low-speed electronic control is used for the motor. It is free from fluctuations in power supply voltage and power supply frequency, and large torque can be obtained with a small amount of electric power. This motor has an inertial mass of 320 kg ・ cm.2Turntable reaches normal speed at 1/2 turn, and quick start is also available.

The turntable is made of die-cast aluminum 35 cm in diameter and 2.0 kg in weight. The dynamic balance of each part is precisely adjusted, and the speed can be finely adjusted with a strobe.

The motor, turntable and player case are made of die-cast aluminum, and the total weight reaches 13.5 kg.

Since the arm base is fixed with screws, it can be attached and detached.

The body is supported by four legs with built-in insulators to cut off external vibration, and the height can be adjusted by turning these legs.

The output terminal is a pin-jack type.

Dust cover is included.

Arm panel (die-cast / wood), strobe light and wood base were sold separately as options.

Model Rating
Type Direct drive player system
<Turntable portion>
Turntable 35 cm Aluminum Die-cast, 2.0 kg
Inertial mass 320 kg / cm2
Motor Ultra-low speed electronic commutator motor
Number of revolutions 33 1/3, 45 rpm
Rotational frequency switching system Electronic control system
Fine adjustment of rotational speed By electronic control system
Rotation speed independent adjustment
Rotational speed adjustment range + / - 5 per cent
Wow flutter 0.03% or less (W. R. M.S.)
Signal-to-noise ratio 60 dB or more
Bootup Normal operation at 1/2 rotation (33 1/3rpm)
<General>
Pwer 100 VAC, 50Hz/60Hz
Power consumption 4.0W
External dimensions Width 510x Height 195x Depth 390 mm
Weight 13.5kg
Sold Separately Arm Panel (Die Cast) SH-11P1 (¥ 3,000)
Arm Panel (Wood) SH-11P1W (¥ 3,000)
Strobe Lighting SH-11L1 (¥ 3,800)
Wood Base SH-11B1 (¥ 4,000)