Audio Database

KT-7000
Commentary

FM/AM tuner equipped with crystal filter and IC.

The IF amplifier, which determines the selectivity characteristics, is equipped with two crystal filters and four high-gain ICs to reduce distortion caused by Tsutomu Oire and improve stereo separation caused by Tsutomu Dainyu.

The front-end uses high-frequency two stage amplification and the mixer stage uses three FETs to improve sensitivity and S / N ratio.

2-meter tuning system allows more accurate tuning.

Model Rating
Type FM/AM Tuner
FM Tuner Section
Receiving frequency 76 MHz to 90 MHz
Sensitivity (IHF) 1.5 μ V
Selectivity 60 dB or more
Distortion factor 0.3% or Less (400 Hz, 100% Modulation)
SN ratio (100% modulation, 100 μ V input) 70 dB or more
Frequency characteristic 20 Hz to 20 kHz ± 0.5 dB
Frequency drift Not more than 0.015%
Antenna input impedance 300 Ω equilibrium
75 Ω unbalance
Capture ratio 1.5 dB or less
Image ratio 90 dB or More (80 MHz)
Spurious response 100 dB or more
IF Rejection 100 dB or more
AM suppression 60 dB or more
Stereo separation 40 dB or More (400 Hz)
Rated output (400 Hz, 100% modulation) 1.5V
<AM Tuner Section>
Receiving frequency 520 kHz to 1610 kHz
Sensitivity 15 μ V (IHF)
Image ratio 80 dB or more
IF interference ratio 70 dB or more
Signal-to-noise ratio (30% modulation, 1 mv input) 45 dB or more
Selectivity 60 dB or more
Rated output (400 Hz, 30% modulation) 0.4V
Output impedance 7k Ω
<General>
Attachment mechanism FM mono to stereo automatic switching device
FM stereo indicator
FM muting
FM center tuning meter
SCA Filters
FM stereo noise filter
Low-impedance output circuit
Tape recording terminal
Mono output terminal
AM bar antenna
Signal meter
Multi-path output terminal
Level adjustment volume
Semiconductor used Transistor : 29
FET : 3
IC : 4
Diode : 28 pcs
Power supply voltage 100 VAC / 117 V, 50Hz/60Hz
Power consumption 20W
External dimensions Width 408x Height 134x Depth 280 mm
Weight 8.2kg