TRIO TW-360
¥ 46,000 (around 1967)
Commentary
An AM/FM stereo receiver developed for high quality and high performance based on experience with the TK-40 and other products already on the market.
The circuit configuration of the amplifier is designed to reproduce without distortion by OTL of ITL and SEPP, and the frequency characteristic is improved especially by using silicon transistor.
The equalizer amplifier uses a direct-coupled amplifier circuit to reduce low-frequency losses caused by CR, etc.
Equipped with an automatic recovery type protection circuit to protect the power transistor.
The tuner section has a 3-row varicon, 5-stage IF amplification, and 4-stage limiter to obtain good sensitivity, S/N and selectivity.
In addition, it is equipped with an automatic switching device between mono and stereo. When stereo reception is received, it can be confirmed by the indicator.
An SCA filter is installed to prevent beat with SCA broadcasting.
Model Rating
Type | AM/FM stereo receiver |
Tuner Section | |
Receiving frequency | FM : 76 to 90 MHz AM : 520 to 1610 kHz |
Sensitivity (IHF) | FM : 2.5 μ V/84MHz AM : 150 μ V/m, 1 MHz |
Image ratio | FM:55dB(84MHz) AM:45dB(1MHz) |
Frequency characteristic | FM : 20 Hz to 20 kHz ± 0.5 dB |
Signal-to-noise ratio | FM : 60 dB or more (100% modulation, 100 μ V input) AM : 45 dB or more (30% modulation, 1 mV input) |
Distortion factor | FM : not more than 0.7% |
Antenna input impedance | FM : 300 Ω Balanced Type |
Frequency drift | FM : not more than 0.02% |
<FM Multi Section> | |
Separation | 38 dB or More (400 Hz) |
Distortion factor | Not more than 0.7% |
Carrier leak | -45dB or less |
Amplifier Unit | |
Effective power | 14W/14W (8 Ω, 1% distortion) |
Music power | 40W (4 Ω, 1% strain) 35W (8 Ω, 1% strain) |
Frequency characteristic | 20 Hz to 50 kHz ± 1 dB |
Output band characteristic | 20 Hz to 60 kHz -3dB (1% distortion, effective output) |
Distortion Factor (1 kHz) | 0.3% or Less (Output 9W/9W) 0.15% or Less (Output 3W/3W) 0.2% or Less (Output 0.3W/0.3W) |
Gain / Impedance (1 kHz) | MAG : 2.1mV/100k Ω AUX, Tape Play : 130mV/50k Ω |
Tone control | 100 Hz : + / - 11 dB 10 kHz : ± 11 dB |
Loudness control (Volume -30dB) | 100Hz:+9dB 10kHz:+3dB |
Equalizer | RIAA |
Noise filter | 6 kHz or higher, 6dB/oct. |
SN ratio (volume maximum, tone control flat) | MAG:60dB AUX, Tape Play : 70 dB |
Residual noise | 1 mV (8 Ω, Volume minimum) |
Damping factor | 20 (8 Ω) |
<General> | |
Accessory circuit | FM mono to stereo automatic switching device FM stereo display lamp 4-stage FM noise limiter SCA Filters AM bar antenna Tape monitor Protection circuit Stereo headphone jack Noise filter Loudness control CR Type Tone Control Mono output terminal DIN standard recording and re-connector |
Semiconductor used | Transistor : 35 Diode : 24 units |
Pwer | 100 VAC / 117 V, 50Hz/60Hz |
Power consumption | No signal : 13W Maximum output : 50W |
External dimensions | Width 420x Height 140x Depth 310 mm |
Weight | 9kg |