Audio Database

KRF-V7771D
Commentary

A multi-channel AV amplifier that supports Dolby Digital and DTS.

Supports DTS (Digital Theater Systems), a digital surround format.
The compression density of DTS is about 1 / 4 of that of Dolby Digital (average), and the average data rate per second is high, so that the amount of information is larger.

It is compatible with 5.1 ch Dolby digital surround by adopting 24 bit precision DSP chip.
Also equipped with Dolby Pro Logic and Dolby 3 stereo, you can enjoy a variety of surround playback depending on the source.
In addition, it is equipped with the Midnight Theater Mode, which is useful for Dolby digital playback when the sound volume cannot be reproduced in the middle of the night. The dynamic range can be controlled by switching from 1 → 2 → off.
(Midnight Theater Mode only works with software that supports dynamic range control)

TRAIT, a high-speed thermal response transistor originally developed by Kenwood, is used for all five channels.
TRAIT was the first in the world to be integrated into a single chip by incorporating a temperature detection and correction circuit, which had previously been externally installed, into a power transistor. Temperature correction, which used to take several minutes, can now be performed almost instantly. This improves dynamic characteristics and allows the operating point to dynamically follow the strength of the music signal.
In addition, the power amplifier section uses a discrete design and is compatible with low impedance.

Equipped with a 5-mode DSP, you can enjoy spatial images such as Arena, Jazz Club, Stadium, Cathedral and Theater.

With a built-in FM/AM stereo synthesizer tuner and a 40-station random preset memory function, you can call up the station you want to listen to with one touch.

Equipped with 20-bit A/D and D/A converters.

It comes with an LCD bi-directional remote control with EL back light. Since the execution result of transmitted commands and setting status are fed back from the body, reliable control is possible while watching the LCD display.
This remote control allows basic settings for surround playback to suit your system, such as speakers and room conditions, as well as controls such as surround mode selection, operation of connected components (registration required), Midnight theater and DSP mode selection.

Model Rating
Type AV Center
<Audio section>
Rated output (stereo, EIAJ) 120W + 120W (20 Hz to 20 kHz, 0.06%, 4 Ω)
Maximum Practical Output (stereo, EIAJ) 180W + 180W (4 Ω)
Maximum output (surround mode
1 kHz, 0.7%, 4 Ω)
Front : 100W + 100W
Center : 100W
Surround : 100W + 100W
Total harmonic distortion factor 0.005% (1 kHz, 60W, 4 Ω)
Dynamic Power 220W (4 Ω)
174W (6 Ω)
140W (8 Ω)
Frequency Response (IHF78) Line (CD) : 5 Hz to 80 kHz + 0. 5-3 dB
Equalizer deviation 20 Hz to 20 kHz ± 0.5 dB
Maximum allowable input MM:120mV(0.2%)
Signal-to-noise ratio (IHF66) Phono MM:77dB
Line(CD):93dB
Tone control characteristics Bass : ± 7 dB (100 Hz)
Treble : ± 7 dB (10 kHz)
Loudness control characteristic
(Volume -40dB)
+7dB(100Hz)
+4dB(10kHz)
Digital Part Input / Output Terminal
Corresponding sampling frequency 32 khz, 44.1 khz, 48 khz
Input Sensitivity / Impedance / Wavelength Optical : -15dBm ~ -21dBm/660nm ± 30 nm
Coaxial : 0.5Vp-p/75 Ω
Analog Part Input / Output Terminal
Input Sensitivity / Impedance Phono MM : 2.5mV/47k Ω
Line (CD, Tuner, AUX, Tape) : 200mV/47k Ω
Output Level / Impedance Tape rec : 200mV/2.2k Ω
Center ch pre out : 1.0V/1.0k Ω
Surround ch pre out : 1.0V/1.0k Ω
Subwoofer pre out : 1.0V/1.0k Ω
<Video Part>
Input Sensitivity / Impedance Composite : 1Vp-p/75 Ω
S-Image : 1Vp-p/75 Ω (Y signal), 0.286Vp-p/75 Ω (C signal)
Output Level / Impedance Composite : 1Vp-p/75 Ω
S-Image : 1Vp-p/75 Ω (Y signal), 0.286Vp-p/75 Ω (C signal)
Signaling system NTSC
FM Tuner Section
Receiving frequency range 76 MHz to 90 MHz
Antenna impedance 75 Ω unbalance
Practical Sensitivity (75 Ω) Mono : 1.6 μ V/15.2 dBf (75kHzSINAD30dB)
Harmonic distortion factor (1 kHz) mono:0.6%
stereo:0.7%
SN ratio (at 1 kHz, 75 kHzdev, 65 dBf input) mono:75dB
stereo:68dB
Stereo separation 36dB(1kHz)
Effective selectivity (± 400 kHz) 50dB
Frequency characteristic 30 Hz ~ 15 kHz + 0.5 -3.0 dB
<AM Tuner Section>
Receiving frequency 531 kHz to 1602 kHz
Practical sensitivity (30% modulation, S/N20dB) 18 μ V (600 μ V/m)
Signal-to-noise ratio (30% modulation, 1 mv input) mono:48dB
stereo:38dB
Stereo separation 30dB
<General>
Power supply voltage 100 VAC, 50Hz/60Hz
Rated power consumption (Electrical Appliance and Material Control Law) 270W
Maximum external dimensions Width 440x Height 162x Depth 391 mm
Weight 11.2kg
Attachment LCD bi-directional remote control with EL backlight