KENWOOD KR-V999D
¥ 105,000 (around 1997)
Commentary
A multi-AV center that supports Dolby Digital.
A 24-bit operation DSP chip is used for the decoder.
This DSP chip performs high-precision internal arithmetic operations of 24 bits or more with an arithmetic operation capacity of 4.4 million operations per second. This DSP chip can maintain sufficient precision in decoding Dolby Digital, where all the processing is done digitally, so that you can enjoy realistic surround sound.
In addition, the DSP chip consumes relatively little power, generates no noise, and reduces the influence on analog circuits to obtain high sound quality.
In addition, a 20-bit precision A/D&D/A converter is used for analog-to-digital conversion processing.
The 5-channel amplifier uses the TRAITR (Thermally Reactive Advanced Instantaneous Transistor) originally developed by Kenwood.
In TRAITR, the temperature detection and correction circuit, which was previously installed externally, is incorporated into the power transistor, making it the first in the world to be integrated into a single chip. Temperature correction, which took several minutes in the past, can be performed almost instantly.
As a result, excellent dynamic characteristics are realized, and the operating point dynamically follows the strength of the music signal.
All 5 channels are designed to be the same, and all channels are equal, enhancing the realistic sensation of dialogue, sound effects, BGM, etc.
OSD (On-Screen Display) for on-screen setup.
Surround Setup, in particular, is a step-by-step setup that allows you to monitor the speaker settings, volume level, and audio input level of the connected device.
In addition, if you set up a remote control macro, you can register automatic operations for multiple devices, such as "Turn on TV → Set TV input → Convert real input to DVD → Turn DVD player power ON".
Equipped with 5-mode DSP of arena, jazz club, stadium, church and theater.
Equipped with Dolby Digital (AC-3) digital in, one optical system and two coaxial systems.
(AC-3RF input can be supported by option DEM 999 d.)
The video input is installed in Line 5 and the output is installed in Route 3. The audio input is installed in Line 5 and the output is installed in 4 systems.
Equipped with AM stereo compatible FM/AM tuner.
Model Rating
Type | Multi-AV center | ||||
<Audio section> | |||||
Rated output (stereo mode) | 150W + 150W (4 ω, 20 Hz-20 kHz, 0.04%) | ||||
Maximum practical output (stereo mode) | 210W + 210W (4 ohm, EIAJ) | ||||
Maximum Output (Surround Mode) | Front : 150W + 150W (4 ohm, 1 khz, 0.7%) Center : 150W (4 Ω, 1 kHz, 0.7%) Surround : 150W + 150W (4 ohm, 1 khz, 0.7%) |
||||
Total harmonic distortion factor | 0.003% (1 kHz, 75W, 4 Ω) | ||||
Damping factor | 180(50Hz) | ||||
Frequency characteristic | Line : 5 hz to 85 khz + 0. 5-3 db | ||||
Equalizer deviation | 20 Hz to 20 kHz ± 0.5 dB | ||||
Maximum allowable input | MM:80mV(0.1%) | ||||
Signal-to-noise ratio | Phono MM:77dB(IHF66) Line:97dB |
||||
Tone control | Bass : ± 10 dB (100 Hz) Treble : ± 10 dB (10 kHz) |
||||
Loudness control (Volume-40dB) | + 10 dB (100 Hz), + 7 dB (10 kHz) | ||||
Input Sensitivity / Impedance | Phono MM : 2.5mV/47k Ω Line : 200mV/47k Ω |
||||
Output Level / Impedance | Tape Rec : 200mV/470 Ω L/R, Center, Surround, Subwoofer Pre Out : 1V/1.2k Ω |
||||
<Video Part> | |||||
Input Sensitivity / Impedance |
|
||||
Output Level / Impedance |
|
||||
Signaling system | NTSC | ||||
FM Tuner Section | |||||
Receiving frequency range | 76 MHz to 90 MHz | ||||
Antenna impedance | 75 Ω unbalance 300 Ω equilibrium |
||||
Practical sensitivity | Mono : 1.2 μ V (75 Ω) / 15.2 dBf (75 kHzdev, SINAD30dB) | ||||
Harmonic distortion factor (1 kHz) | mono:0.6% stereo:0.7% |
||||
SN ratio (1 kHz 75kHzdev/65dBf input) | mono:75dB stereo:68dB |
||||
Stereo separation | 40dB(1kHz) | ||||
Effective selectivity (± 400 kHz) | 50dB | ||||
Frequency characteristic | 30 Hz ~ 15 kHz + 0.5 -3.0 dB | ||||
<AM Tuner Section> | |||||
Receiving frequency | 531 kHz to 1602 kHz | ||||
Practical sensitivity (30% modulation, S/N20dB) | 16 μ V (600 μ V/m) | ||||
Signal-to-noise ratio (30% modulation, 1 mv input) | mono:48dB stereo:38dB |
||||
Stereo separation | 30dB | ||||
<General> | |||||
Power supply voltage | 100 VAC, 50Hz/60Hz | ||||
Rated power consumption (Electrical Appliance and Material Control Law) | 330W | ||||
Maximum external dimensions | Width 440x Height 162x Depth 392 mm | ||||
Weight | 13kg | ||||
Attachment | GUI Remote Controller RC-R0905 |