TRIO KA-3300
¥ 34,500 (around 1975)
Commentary
Pre-main amplifier using FET differential amplification ICL system.
The equalizer amplifier uses an ICL (input capacitor-less) method that eliminates the input capacitor, which is the cause of sound quality degradation. The FET differential amplification method is used in the first stage. This reduces phase deviation and distortion.
All stages are directly connected + pure complimentary service OCL circuit is adopted for the circuit system of the power amplifier section.
In particular, the output stage is equipped with a newly developed Power Darlington Block, an acoustic element composed of four transistors and a temperature compensation circuit. It uses a triple diffused 40W block at 35W with a margin to achieve a low distortion factor and a wide plate with high thermal radiation efficiency and improved stability.
Two 6,800 μ F large-capacity capacitors are used for the power supply.
In order to prevent shock noise when the power is turned ON/OFF, a delay start circuit is installed to delay the start of operation of the power amplifier until the preamplifier stabilizes DC.
Uses a volume knob with 41 contacts and a tone control knob with 11 contacts.
There was a Brazilian rose finish wood case sold separately.
Model Rating
Type | Integrated amplifier | ||||
Power Amplifier Unit | |||||
Rated Output (Both Channel Operation) |
|
||||
Music Power (IHF) | 100W (4 Ω) 96W (8 Ω) |
||||
Total harmonic distortion factor | 0.8% (8 Ω at rated output) 0.08% (8 Ω at rated output of -3dB) |
||||
Cross modulation distortion factor | 0.5% (8 Ω at rated output) 1% (8 Ω at rated output -3dB) |
||||
Output Bandwidth Characteristics (IHF) | 10 Hz to 40 kHz | ||||
Damping factor | 30 | ||||
Optimum load impedance | 4 Ω ~ 16 Ω | ||||
Preamplifier Section | |||||
Input Sensitivity / Impedance | Phono : 2.5mV/50k Ω Tuner, aux, tape play : 150mV/25k Ω |
||||
Maximum Allowable Input (1 kHz) | phono:210mVrms | ||||
Output level | tape rec(pin):150mV | ||||
Signal-to-noise ratio | phono:70dB Tuner, aux, tape play : 90 dB |
||||
Frequency characteristic | Phono : RIAA deviation ± 0.8 dB Tuner, aux, tape play : 20 Hz to 20 kHz ± 2 dB |
||||
Tone control | Bass : + / - 8 dB (100 Hz) Treble : ± 8 dB (10 kHz) |
||||
Loudness control (at rated output of -30dB) | 100Hz:+6dB 10kHz:+4dB |
||||
<General> | |||||
Power outlet | Power switch interlock : 2 systems Power switch not linked : 1 system |
||||
Power supply voltage | 100 VAC, 50Hz/60Hz | ||||
Rated power consumption (Electrical Appliance and Material Control Law) | 90W | ||||
External dimensions | Width 380x Height 140x Depth 255 mm | ||||
Weight | 7.5kg | ||||
Sold Separately | Wood Case SRA-3000 (¥ 4,500) |