SONY TA-S2
¥ 38,000 (around 1995)
Commentary
This is a pre-main amplifier of the Component Series that was developed to be combined with the SS-S2 speaker system.
A MOS FET is used in the final stage of the amplifier circuit. Since the input impedance of the MOS FET is high, the driver stage and the output stage can be electrically separated to reduce interference with each other. Thus, high sound quality can be obtained with a relatively simple circuit structure, and odd-order distortion, which is easy to hear, can be suppressed.
In addition, the super legato linear system is adopted to reduce switching distortion and crossover distortion.
S. T. D. (Spontaneous Twin Drive) power supply is used for the power supply part.
In the S. T. D. power supply, the voltage amplifier stage (A-class stage) and the power amplifier stage (B-class stage) are separately and independently supplied with power from the rectifier circuit. Thus, even at high output, changes in the power supply voltage of the power amplifier stage do not adversely affect the power supply of the voltage amplifier stage, thus improving sound quality.
The Advanced S. T. D. power supply is a further development of this system. An induction coil is added to the voltage amplification stage to reduce voltage fluctuations during rectification. A large-capacity capacitor is also equipped to supply a large instantaneous current, thereby improving sound quality in the middle and high frequency range, S / N ratio and dynamic range.
Equipped with a source direct switch that bypasses the tone control circuit, etc.
Wireless remote control is included.
Model Rating
Type | Pre-main amplifier |
Effective power (EIAJ) | 50W + 50W (6 Ω) |
Input Sensitivity / Impedance | Phono MM : 2.5mV/50k Ω Line system : 150mV/50k Ω |
Output Level / Impedance | Headphone : 2.5 mW (8 Ω) |
Frequency characteristic | 10 Hz ~ 500 kHz + 0 -3dB |
Signal-to-noise ratio | Phono MM:85dB Line system : 100 dB |
Tone control | Bass : ± 7 dB (100 Hz) Treble : ± 6 dB at 10 kHz |
Accessory function | Source direct switch Remote Commander |
Pwer | 100 VAC, 50Hz/60Hz |
Power consumption | 75W |
External dimensions | Width 310x Height 90x Depth 360 mm |
Weight | Approx. 5.5 kg |
Attachment | Wireless Remote Control RM-S1 |