SONY TA-1150D
¥ 59,800 (around 1975)
Commentary
This is a pre-main amplifier developed by inheriting the technology of F group, a high-end machine of Sony.
The power amplifier section uses a differential amplifier, two power supplies directly connected to all stages, and a pure complimentary service and parallel push-pull circuit.
The equalizer amplifier uses a newly developed dual FET, which is a package of two FETs with high input impedance, and combines a FET differential amplifier with a low-noise IC developed for audio.
In addition, a constant voltage circuit is installed to improve sound quality.
The flat amplifier uses a high-voltage low-noise IC.
The volume knob is designed to be a 4-channel master volume.
It uses tone control with turnover frequency switching.
The circuit uses the NFB method with good characteristics and low distortion.
All-push button type input selector is adopted.
Center channel terminal is mounted.
Built-in speaker protection circuit.
The preamp and power amp can be connected / disconnected.
Model Rating
Type | Stereo pre-main amplifier | ||||
Power Amplifier Unit | |||||
Circuit system | Direct-coupled pure complimentary service symmetric SEPP circuit | ||||
Dynamic Power (IHF) | 100W (8 Ω) | ||||
Effective output (both channel drive) | 35W + 35W (8 ohm, 1 khz) 30W + 30W (8 Ω, 20 Hz to 20 kHz) |
||||
Output Bandwidth Characteristics (IHF) | 8 Hz to 35 kHz | ||||
Harmonic distortion factor | 0.2% or Less (Rating) 0.1% or Less (at 1W) |
||||
Cross modulation distortion factor (60Hz:7kHz=4:1) |
0.2% or Less (Rating) 0.1% or Less (at 1W) |
||||
Damping factor | 100 or More (1 kHz, 8 Ω) | ||||
Signal-to-noise ratio | 110 dB or more (IHF-A network, closed circuit) | ||||
Preamplifier Section | |||||
Phono input | Phono1, 2 : 2mV/47k Ω | ||||
Phono maximum allowable input | Phono1, 2 : 70 mV | ||||
PhonoSN ratio | Phono1, 2 : 70 dB or more (input 2 mV, B network) | ||||
Output Level / Impedance | Rec out1, 2 : 140mV/10k Ω Pre out : 0.8v/2.7k Ω |
||||
Loudness control (Volume-30dB) |
+10dB(50Hz) +3dB(10kHz) |
||||
Tone control |
|
||||
Filter | Low : 100 Hz or less, 6dB/oct. High : 5 kHz or higher, 6dB/oct. |
||||
<General> | |||||
Power outlet | Power switch interlock : 2 systems Power switch not linked : 1 system Total 500W |
||||
Power consumption | 120W | ||||
External dimensions | Width 400x Height 149x Depth 316 mm | ||||
Weight | 8.3kg |