ROTEL RA-810
¥ 55,000 (around the early 1970 s)
Commentary
A pre-main amplifier that uses a 2-power supply system and power amplifier circuit directly connected to all stages.
The preamplifier section has a 3-stage direct connection circuit with low-noise silicon transistors and E-E feedback to maintain a highly stable equalizer characteristic.
In addition, noise is reduced by adopting 3-stage direct-coupled circuit of PNP transistor only.
Equipped with a dubbing circuit that allows easy recording from one tape recorder to another.
A protective circuit that protects the speakers and transistors protects them from accidents caused by shorting of the speaker terminals.
Model Rating
Type | Solid-state stereo amplifier |
Main Amplifier Section | |
Music Power (IHF) | 4 Ω : 180W 8 Ω : 125W |
Effective power (RMS) | 4 Ω : 60W + 60W 8 Ω : 40W + 40W |
Harmonic distortion factor | 40W output : 0.3% (20 Hz to 20000 Hz) |
Cross modulation distortion factor | 40W output : 0.2% |
Frequency characteristic | 4 hz to 75,000 hz, + 0 -3dB |
Output band characteristic | 5 Hz to 50,000 Hz |
Damping factor | 35 (8 Ω) |
Input Sensitivity / Impedance | 1V/33k Ω |
Speaker impedance | 4 Ω ~ 16 Ω |
Preamplifier Section | |
Output voltage | 1 V ~ 3 V |
Harmonic distortion factor | 0.1% |
Frequency characteristic | 3 Hz to 50,000 Hz, + 0 -3dB |
Signal-to-noise ratio | Phono1, 2 : 65 dB AUX1, 2, Tape In : 75 dB |
Residual noise | 0.5mV |
Input Sensitivity / Impedance | Phono1 : 2mV/50k Ω Phono2 : 2, 4, 8mV/30, 50, 100k Ω Tuner, AUX1, 2, Tape In : 115mV/40k Ω Tape DIN : 330mV/100k Ω |
Equalizer | Within ± 0.5 dB deviation from RIAA standard curve |
Loudness | 50Hz:+10dB 10kHz:+4dB |
High filter | 10kHz:-10dB |
Low filter | 50Hz:-10dB |
Muting | 10kHz:-20dB |
Bass | 50 Hz : + / - 10 dB |
Treble | 10 kHz : ± 10 dB |
<General> | |
Power supply voltage | 100 V, 117 V, 220 V, 240 V, 50Hz/60Hz |
Power consumption | 130W |
External dimensions | Width 420x Height 140x Depth 304 mm |
Weight | 10kg |