Pioneer S-61X
¥ 141,000 (around 1964)
Commentary
A separate stereo developed as a top-of-the-line model.
Receiver / player part
An aluminum die-cast turntable is used for the player.
The receiver section can receive up to three analog TV channels.
In addition, it is equipped with functions such as rumble and scratch filter.
The exterior has a walnut oil finish.
Speaker part
A 3-way speaker is used for the speaker section.
A 25 cm cone woofer is installed in the low range and a 16 cm cone squaker is installed in the middle range.
A horn type tweeter is installed in the high-frequency range.
Model Rating
| Type | Stereo system | |
| <Player Part> | ||
| Drive motor | 4-pole synchronous motor | |
| Turntable | 30 cm aluminum die-cast, 1.4 kg | |
| Cartridge | MM Type | |
| Needle tip | 0.7 mil diamond needle | |
| Tone arm | Dynamically balanced pipe arm | |
| Frequency characteristic | 20 Hz to 20 kHz | |
| Receiver Section | ||
| Receiving frequency | FM | 76 mhz to 108 mhz |
| AM(MW) | 535 kHz to 1,605 kHz | |
| SW | 3.8 mhz to 12 mhz | |
| Maximum power output | 14W+14W | |
| Distortionless output | 12W+12W | |
| Accessory circuit | FM-AFC Switching Method FM-MPX Scratch rumble filter Loudness control Headphone port |
|
| Vacuum tube used | 20 balls and 10 stones | |
| Maximum Power Consumption | 134VA | |
| Speaker Unit | ||
| Method | 3-way, 3-speaker floor type | |
| Units Used | For low band : 25 cm cone type For Medium Range : 16 cm cone type For High Frequency : Horn Type |
|
| Frequency characteristic | 45 Hz to 20 kHz | |
| <General> | ||
| External dimensions | Width 1,620x Height 840x Depth 420 mm | |
| Weight | 93kg | |