|260,000yen( It is 1 set in two sets, 1995 release)
The speaker system completed as a natural phase system based on the original
wave-front control technology of Pioneer, and the network less technology.
A natural phase system is "the enclosure which coincided the voice
source of a Woofer and a tweeter and performed theoretical phase doubling",The
three-position of "smooth-izing of the electric phase response by
a network less technology" and "the form which prevents a wave-front
diffraction and fully pulls out the performance of each speaker unit"
is considered as the point, and a spread of a uniform sound and a smooth
phase response are realized by practicing these.
The 16cm cone type Woofer is
carried in low-pass.
Edge form was begun, about all suspension systems, he
examined form and materials one by one, and the flattery nature from a minute
input is strengthened.
Moreover, the failure factor of an input signal is eliminated as much as
possible by carrying out direct connection without a network by the network
The 3.5cm semi dome shape tweeter
is adopted as a high region.
This tweeter is a newly developed HSDOM
(Harmonized Synthetic Diaphragm Optimum Method) tweeter which uses a ceramic
graphite,Using the finite element method by computers, such as a material of a
diaphragm, form, and an edge, it is designed so that each functionality and
performance can demonstrate to the maximum extent.
Zinc die-casting with
2.6 times as much specific gravity as aluminum is adopted as the frame of a
Woofer, and the flange of a tweeter, it is in them, and the vibration
suppression effect is raised to them.
Moreover, the mid ship mounting scheme
was adopted as mounting of a unit, and the shake of the magnetic circuit by
drive of a cone is prevented.
It is a simple network which uses the capacitor which restricts a low-pass
swing to tweeters by a network less technology.
The CGR (Capacitive Gap Reduction) system which made full use of a
TAD (Technical Audio Devices) technology is introduced, the unnecessary
electrostatic electric charge generated near the signal current is reduced, and
high-quality sound-ization by a clean signal is attained.
board with a thickness of 67mm which begins to delete mahogany with the
sufficient acoustic feature to an enclosure from a plank was begun, and a thrust
board, the base, etc. are adopted as all.
Moreover, in order to stop the
diffraction phenomena of sound, the baffle side is made into the minimum
dimension to the magnitude of a unit, and the wave front is controlled by
performing a still more peculiar taper treatment.
The enclosure has
adopted the design which became the exclusive base and an integral type, and
makes it a main unit and the floating structure which uses felt packing between
the bases, and the tone-quality transition by installation requirements is
This floating base can be detached and attached.
optional exclusive table lamp has also adopted total design and design, and is
made for the first time in the inside of 18 degrees, without changing the
location of a table lamp.
||2 ways, 2 speaker bass-reflex scheme, a
bookshelf type, and a magnetic-shield design (EIAJ)
||For low-pass: 16cm cone type
regions: 3.5cm semi dome shape
|Play frequency band
||40Hz - 50000Hz
|Output sound pressure level
|The maximum input
|Cross over frequency
||Width 240x height 468x depth of 340mm
|Option: Speaker table lamp CP-07 ( It is 1 set in two sets, 80,000yen)
||Width 320x height 515x depth of 370mm