Pioneer SA-520
¥ 29,800 (around 1973)
Commentary
An authentic pre-main amplifier designed for ease of use.
All stages of the power amplifier are connected to a semi-power complimentary service system. The first stage is equipped with an operation amplifier and an input bias compensation circuit to achieve high DC stability.
The equalizer amplifier is a 2-stage direct-coupled system that combines a low-noise transistor with a low-noise resistor and a styrofoam capacitor to improve S/N and stability.
CR-type tone control has been adopted, and in pursuit of component accuracy, the tone control knob has obtained characteristics with less waviness in the frequency characteristics in the flat position.
Model Rating
Type | Stereo pre-main amplifier | ||||||||
Power Amplifier Unit | |||||||||
Circuit system | Semi-direct complimentary service for all 1st stage | ||||||||
Effective power |
|
||||||||
Harmonic distortion factor | Effective power : 0.8% or less 0.2% or less at 1W output |
||||||||
Cross modulation distortion factor | Effective power : 0.8% or less 0.4% or less at 1W output |
||||||||
Output bandwidth | 10 Hz ~ 40 kHz (IHF, double-channel drive, 0.8% distortion factor) | ||||||||
Output terminal | Speaker : A, B, A + B (4 Ω ~ 16 Ω) Headphone : 4 Ω ~ 16 Ω |
||||||||
Damping factor (1 kHz, 8 Ω) | 30 or more | ||||||||
Residual noise (8 Ω, pre + power amplifier) | 1 mV (0.13 μ W) or less | ||||||||
Preamplifier Section | |||||||||
Circuit system | Equalizer amplifier : 2-stage direct connection NFB type Control Amplifier : CR Type |
||||||||
Input Sensitivity / Impedance | Phono : 2.5mV/50k Ω Tuner, AUX1, 2, Tape Monitor1, 2 (DIN) : 150mV/100k Ω |
||||||||
Phono maximum allowable input (rms/P-P) | 100mV/280mV | ||||||||
Output Level / Impedance | Tape Rec:150mV Tape Rec (DIN) : 30mV/80k Ω |
||||||||
Frequency characteristic | Phono (RIAA deviation) : 30 Hz to 15 kHz ± 0.5 dB Tuner, AUX, Tape Mon : 15 Hz to 30 kHz ± 1 dB |
||||||||
Tone control | Bass : + 12 dB ~ -10dB (100 Hz) Treble : + 9.5 dB ~ -10.5 dB (10 kHz) |
||||||||
Loudness contour at volume -40dB | + 10 dB (100 Hz), + 6 dB (10 kHz) | ||||||||
Signal-to-noise ratio (IHF, short circuit A network) |
Phono : 70 dB or more Tuner, AUX, Tape Mon : 90 dB or higher |
||||||||
<General> | |||||||||
Semiconductor used | Transistor : 22 Diode : 6 pcs |
||||||||
Power supply voltage | 100 VAC, 50Hz/60Hz | ||||||||
Power outlet | Power switch interlock : 1 system Power switch not linked : 2 systems |
||||||||
Power consumption | Rating : 42W Maximum : 85W |
||||||||
External dimensions | Width 415x Height 132x Depth 328 mm | ||||||||
Weight | 7.1kg |