Pioneer QX-401
¥ 68,000 (released in 1972)
Commentary
This is a 4 ch receiver that can play a variety of 4 channels.
Discrete 4-channel tape playback, regular / SQ matrix 4-channel, and CD-4 disc playback with a demodulator.
FET is used for the FM front end, and IC and ceramic filter are used for the IF part to improve selectivity.
In addition, the linear type dial scale and large meter are adopted, and accurate tuning point catch is possible.
A muting switch is installed to prevent unpleasant inter-station noise.
Each front and rear has its own tone control.
In addition, it is equipped with 3 balance control which can control the balance of front left and right, rear left and right, front and rear.
Two pairs of rear speakers can be connected simultaneously.
Model Rating
Type | 4-channel receiver | ||||||
FM Tuner Section | |||||||
Practical sensitivity (IHF) | 2.2 μ V | ||||||
Capture Ratio (IHF) | 3.0dB | ||||||
Effective selectivity | 45 dB or more | ||||||
S/N | 65dB | ||||||
Image Interference Ratio (82 MHz) | 55 dB or more | ||||||
IF Interference Ratio (78 MHz) | 80 dB or more | ||||||
Spurious interference ratio | 85 dB or More (82 MHz) | ||||||
AM suppression ratio | 50dB | ||||||
Harmonic distortion factor (100% modulation) | Mono : not more than 0.6% Stereo : 0.8% or less |
||||||
Stereo separation | 40 dB or More (1 kHz) | ||||||
Residual carrier level | 35 dB or more | ||||||
Antenna | 300 ohm balanced 75 Ω Unbalanced Type |
||||||
Muting | ON/OFF enabled | ||||||
<AM Tuner Section> | |||||||
Practical sensitivity (IHF) | 15 μ V | ||||||
Selectivity (1 MHz) | 25 dB or more | ||||||
S/N (30% modulation) | 50dB | ||||||
Image Interference Ratio (1 MHz) | 45 dB or more | ||||||
IF interference ratio | 30 dB or more | ||||||
Antenna | Ferrite bar antenna | ||||||
Amplifier Unit | |||||||
Music Power (IHF) | 108W (4 Ω) 80W (8 Ω) |
||||||
Effective power |
|
||||||
Harmonic distortion factor | 1% or Less (Effective Output) | ||||||
Cross modulation distortion factor | 1% or Less (Effective Output) | ||||||
Output Bandwidth (IHF) | 2 ch Drive : 10 Hz to 30,000 Hz 4 ch Drive : 15 Hz ~ 20,000 Hz |
||||||
Frequency characteristic | 10 Hz to 100,000 Hz ± 3 dB | ||||||
Damping factor | 40 (8 Ω, 1 kHz) | ||||||
Input Sensitivity / Impedance (1 kHz at effective output) |
Phono MAG : 2.3mV/50k Ω AUX, Tape Mon : 200mV/90k Ω |
||||||
Recorded output | Tape Rec (pin-jack) : 200 mv Tape Rec(DIn):19mV |
||||||
Tone control | Bass : 100 Hz, -12.5 dB to + 13 dB Treble : 10 kHz, -8.5 dB to + 11.5 dB |
||||||
Equalizer | RIAA S.T.D | ||||||
Loudness (at volume -40dB) |
100Hz:+10dB 10kHz:+5dB |
||||||
Hum and noise (IHF) | Phono : 70 dB or more AUX : 90 dB or more |
||||||
<General> | |||||||
Rated power consumption | 75W | ||||||
Maximum Power Consumption | 150W | ||||||
External dimensions | Width 450x Height 144x Depth 350 mm | ||||||
Weight | 10.1kg |