Pioneer A-D1
¥ 26,800 (released in June 2000)
Commentary
A pre-main amplifier developed with the technology of advanced equipment.
Direct Energy MOS-FET is used as the power element. Since the resistance value of Direct Energy MOS-FET during operation is very small, it is possible to set the supply voltage low. This minimizes energy loss which adversely affects sound quality, and realizes excellent power linearity, low load drive capability and compact circuit.
In addition, they are fixed extruded material heat sinks to eliminate mutual interference.
Sound stabilizer is used in the chassis structure.
This system consists of a transformer stabilizer for the power transformer and a chassis stabilizer that does not transmit external vibration to the inside. This system increases the rigidity of the entire housing.
In addition, we have adopted an aero wing chassis whose rigidity has been increased by computer analysis.
Wide range linear circuit is used for the circuit structure.
This circuit uses a simple circuit configuration to obtain the necessary gain by current feedback type one stage amplification. It has excellent power supply linearity and enables a speaker drive with stable output impedance characteristics over a wide range.
A silent microcomputer is used in the operation section to minimize the influence on the SN ratio during actual use by operating only when necessary.
It is equipped with sound adjustment functions such as tone control and loudness.
It also has a direct switch that passes through balance and tone circuits, allowing you to enjoy fresher sound.
Equipped with SR terminal that can be linked with Pioneer's component.
Equipped with phono input.
Wireless remote control is included.
Model Rating
Type | Pre-main amplifier |
Maximum practical power | 75W + 75W (EIAJ, 4 Ω) |
Rated Output (Both channel drive) | 45W + 45W (4 ohm, 20 hz to 20 khz, 0.15%) 35W + 35W (8 ω, 20 Hz to 20 kHz, 0.1%) |
Input Sensitivity / Impedance | Phono MM : 2.8mV/50k Ω CD, Tuner, Aux, Tape1/CD-R/MD, Tape2/Monitor : 200mV/50k Ω |
Phono maximum allowable input | Phono MM : 150 mV (1 kHz, 0.1%) |
Output Level / Impedance | Tape1/CD-R/MD, Tape2/Monitor : 200mV/1k Ω Tape rec : 200mV/1k Ω |
Frequency characteristic | Phono MM : 20 Hz to 20 kHz ± 0.3 dB CD, Tuner, Aux, Tape1/CD-R/MD, Tape2/Monitor : 5 Hz to 100 kHz + 0 -2dB |
Tone control | Bass : ± 8 dB (100 Hz) Treble : ± 8 dB (10 kHz) |
Loudness contour (Vol -30dB) | + 5 dB (100 Hz), + 3 dB (10 kHz) |
Signal-to-noise ratio (IHF, A-network, short circuit) |
Phono MM:85dB(at 5mV) CD, Tuner, Aux, Tape1/CD-R/MD, Tape2/Monitor : 106 dB |
Speaker load impedance | A, B : 4 Ω ~ 16 Ω A + B : 8 Ω ~ 32 Ω |
AC outlet | Power Switch Interlock : 2 Systems (100W) Power switch not linked : 1 system (100W) |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 100W (Electrical Appliance and Material Control Law) |
External dimensions | Width 420x Height 114x Depth 307 mm |
Weight | 4.7kg |
Attachment | Wireless Remote Control |