ONKYO D-5RX
¥ 53,000 (1 unit)
Commentary
A lower model of D-7RX. The basic design is the same, and this is a smaller design.
The vibration plate of the woofer is made of two layers of carbon that are separated by a 45 ° angle. The rigidity characteristic of carbon is exhibited in all directions. In addition, a special epoxy resin is used for the binding material used in cone molding to ensure a large internal loss without damaging the original characteristics of carbon such as high rigidity and light weight, and to eliminate the natural sound of the material.
The Skoka diaphragm uses a delta-olefin refined diaphragm with four times the rigidity by adding an additive compound to delta-olefin.
A magnesium alloy diaphragm is used for the tweeter, and a computer analysis diffuser is attached to the diaphragm to achieve high resolution in a wide listening area.
For the network, we have adopted a concentrated single-point earth by applying amplifier circuit technology and a split type network of Woofer circuit / Squaker / Tweeter circuit to eliminate interference between units and networks and improve sense of orientation.
A rigid anti-vibration material (mixed material of mica and butyl rubber) is filled in the contact part of the Woofer / Scoker unit with the cabinet to protect accurate piston motion from unwanted interference.
Model Rating
Method | 3-way 3-speaker, bass reflex system, bookshelf type |
Units Used | For low band : 28 cm cone type For Medium Range : 10 cm Cone Type For high-pass : 2.5 cm dome type |
Playback frequency band | 33 Hz to 45000 Hz |
Max Input | 120W |
Impedance | 6 Ω |
Output sound pressure | 91dB/W/m |
Crossover frequency | 700 Hz, 3500 Hz |
Cabinet internal volume | 45L |
Level control | midrange and tweeter independent level control |
External dimensions | W 330x H 610x D 324 mm (w / RUNNET) |
Weight | 17kg |