ONKYO CP-60A
¥ 36,500 (around 1974)
Commentary
Belt drive record player with full auto mechanism with muting circuit.
Equipped with muting circuit to cancel minute mechanical noise at full auto start.
A belt drive system using a 4-pole synchronous motor and a polyurethane belt is used for the drive part.
In addition, a 30 cm aluminum die-cast table with good balance accuracy is used for the turntable.
The tone arm uses a static balance pipe arm with the bearing raised by special Teflon processing.
It uses counterweights and 4P connector detachable head shell.
The cartridge is a VM type cartridge.
It uses a shock absorption type insulator that is resistant to external vibration.
A low-volume connection code is used to support 4-channel playback.
Equipped with a removable fleece top dust cover.
Model Rating
Type | Belt drive player |
<Turntable portion> | |
Turntable | 30 cm aluminum die cast, weight 1.1 kg |
Drive system | Belt drive |
Motor | 4-pole synchronous motor |
Number of revolutions | 33 1/3, 45 rpm |
Wow flutter | Not more than 0.08% |
Signal-to-noise ratio | 48 dB or more |
Tone Arm Section | |
Tone arm | Static balance S-shaped pipe arm |
Effective length | 210mm |
Overhang | 15mm |
Tracking error | Within ± 1.5 ° |
Cartridge Section | |
Cartridge | VM type cartridge |
Frequency characteristic | 20 Hz to 25 kHz |
Output voltage | 3.5mV(1kHz) |
Output balance | 2.5 dB or Less (1 kHz) |
Separation | 25dB(1kHz) |
Compliance | 10x10-6cm/dyne |
Proper needle pressure | 2.0g |
Needle tip | 0.5 mil diamond needle |
Exchange needle | DN-27ST |
Load impedance | 50k Ω |
<General> | |
Attachment mechanism | Full auto mechanism Manual lifter Lateral balancer Anti-skating system |
Power consumption | 10W |
External dimensions | Width 480x Height 190x Depth 400 mm |
Weight | 9.5kg |