ONKYO Integra 725
¥ 45,900 (around 1969)
Commentary
A pre-main amplifier that uses all stages of direct-coupled circuits in the main amplifier section.
The preamp section, especially the equalizer section, has been thoroughly analyzed to improve the equalizer allowable input.
Model Rating
Type | Pre-main amplifier |
Power Amplifier Unit | |
Circuit system | All-stage direct-coupled circuit |
Rated Output (THD 0.1%, 1 kHz) | 22W + 22W (8 Ω) |
Dynamic Power (IHF) | 70W (8 Ω) |
Total harmonic distortion rate (1 kHz) | 0.1% or Less (at Rated Output) 0.05% or Less (at 10W Output) |
Frequency characteristic | 15 Hz to 70 kHz, 0 -1dB |
Power Band With (IHF) | 10 Hz to 100 kHz -3dB |
Damping factor | 60 (DC ~ 30 kHz) |
Signal-to-noise ratio (IHF A network) | 100 dB or more |
Rated input voltage / impedance | 1V/100k Ω (10 Hz to 50 kHz) |
Load impedance | 4 Ω ~ 16 Ω |
Gain | 22dB |
Preamplifier Section | |
Distortion Factor (1 kHz, 1 V Output) | Not more than 0.05% |
RIAA deviation (30 Hz to 15 kHz) | Within ± 0.5 dB |
Equalizer allowable input | 200mV(1kHz) 930mV(10kHz) |
Signal-to-noise ratio (IHF-A) | Phono1, 2 : 75 dB or more AUX, Tuner : 90 dB or more |
Input Sensitivity / Impedance (1 kHz) | Phono1, 2 : 2.4mV/50k Ω, 100k Ω switching AUX : 100mV/100k Ω Tuner, Tape moni : 100mV/100k Ω |
Tone control | Bass : ± 10 dB (100 Hz) Treble : ± 10 dB (10 kHz) |
<General> | |
External dimensions | Width 313x Height 136x Depth 366 mm |
Weight | 8kg |