Audio Database

Image of DA-R320
Commentary

An FM/AM receiver that is a sister machine of the DA-R340.

The power amplifier section increases the drive performance of low-impedance speakers by increasing the power ratio to 2.6.
It is also equipped with CR-type tone control and loudness mechanism.

Phase linear ceramic filters, monolithic ICs with excellent limiter effects, and dispersion transformers with peak separation of 1 MHz are used in the FM and IF stages.

The FM and MPX stages employ double-balanced differential demodulation ICs and mold transformers with high Q and excellent temperature and humidity resistance characteristics.

An FM muting circuit is mounted. In this circuit, the bias condition of the transistor of the muting circuit is fixed by the substitution method regardless of ON/OFF of the muting operation, so that the pop noise is reduced.

The AM and IF stages use triple tune IFT to enhance the AM receiving mechanism.

Equipped with a microphone mixing circuit.

The FM DET out terminal is provided to connect the decoder for FM4ch.

Equipped with a selector position indicator.

Model Rating
Type AM/FM Receiver
<Audio section>
Output
Both channel operation : 14W + 14W (4 Ω)
11W + 11W (8 Ω)
Single channel operation : 18W/18W (4 Ω)
13W/13W (8 Ω)
Music 44W (4 Ω)
30W (8 Ω)
EIAJ: 30W (4 Ω)
Power bandwidth 20 Hz to 50 kHz
Harmonic distortion factor 0.8% (at rated output)
0.06% at 1W output
Frequency characteristic Phono:RIAA STD
Aux : 20 Hz to 30 kHz ± 1 dB
Input Sensitivity / Impedance Phono : 2.5mV/50k Ω
Aux : 150mV/60k Ω
Playback : 150mV/50k Ω (pin), 300mV/50k Ω (din)
Mic : 1mV/40k Ω
Recorded output Rec1, 2 : 150 mV (pin), 30 mV (din)
Tone control Bass : ± 10 dB (100 Hz)
Treble : ± 10 dB (10 kHz)
Residual noise 0.5mV
Input reduced noise Phono:-118dB(V)
Aux:-100dB(V)
Mic:-124dB(V)
FM Tuner Section
Antenna 300 Ω balanced, 75 Ω unbalanced
Practical sensitivity 1.8 μ V (IHF)
Effective selectivity 60dB(IHF)
Capture ratio 1.5dB(IHF)
Image interference ratio 60dB(IHF)
IF interference ratio 70dB
1/2 IF interference ratio 60dB
AM suppression ratio 50dB
S/N 70dB
Harmonic distortion factor (100% modulation) mono:0.2%
stereo:0.5%
Separation 40dB(1kHz)
30dB(10kHz)
Muting ON / OFF Enabled
<AM Tuner Section>
Antenna With Ferrite Bar Antenna
Practical sensitivity 55 dB (Bar Antenna S/N 30 dB)
Selectivity 35 dB (± 10 kHz)
Image interference ratio 40dB
S/N 50dB
<General>
Power consumption 53W
External dimensions Width 450x Height 146x Depth 330 mm
Weight 9.9kg