MARK LEVINSON LNP-2L
¥ 1,180,000 (released in 1977)
¥ 1,520,000 (around 1982)
Commentary
A preamplifier that was born as the highest peak of modern amplifier.
The LNP-2L has been replaced with the original ML module specifications from the Burwen Corporation which was used in the LNP-2.
The amplifier consists of three stages : a phono amplifier, an input amplifier, and an output amplifier. Each stage has one module per channel, and each stage has one module for the meter. There are eight modules in total.
The LEMO connector is a CAMAC-type connector used for special applications such as medical devices and physical measuring instruments. The LEMO connector is also used for the tape input / output and main out output. The LEMO connector is also used for the tape input / output and main out output.
We put top-of-the-line products into parts such as volume and changeover switch.
The meter is made by Weston and can be switched to VU or peak with a special module. In the HF + position, it can be adjusted to high frequency so that it can be used in cassette recording.
The power supply unit (PLS-153L) is separated.
Model Rating
Type | Preamplifier |
<General> | |
Configuration | Eight module configuration 2 peak reading amplifiers for meter 3-stage amplifier configuration using 3 units each of 2 channels Two spare module sockets |
Input impedance | Phono : 50k Ω High Level : 11.5k Ω or more |
Output level | Record out1, 2, main out : about 10 Ω (Applicable Load Impedance 600 Ω or More) |
Maximum power output | 8Vrms |
Gain | Overall : 60 dB Phono Amplifier : 30 dB (1 kHz) Input amplifier : 20 dB Output amplifier : 10 dB |
Gain control | Input amplifier : 0, 5, 10, 15, 20 dB Output Amplifier : 0, 10 dB |
Level control | 2 ch independent input level volume for input amplifier : 0 ~ -40dB, ∞ Output Level Volume : 0 ~ -40dB, ∞ |
Tone control | Low : ± 8 dB (20 Hz) Mid : ± 3 dB (5 kHz or more shelving) High : ± 8 db (20 kHz) Low / High : 2 dB steps, 9 positions Mid : 1 dB step, 7 positions |
<Meter display> | |
Meter | The meter is WESTON precision grade and constantly monitors the recording output level. |
As a VU meter | 0VU=0.775dB 0dBm Switchable to 0.387 v -6dBm and 1.228 v + 4 dbm |
As a peak meter | 0VU=2.449V +10dB Attack time : 5 μ sec Peak hold time : about 2 sec Response : 10 hz to 30 khz Flat |
As an HF + peak meter | High-frequency preemphasis display of + 8.5 dB at 20 kHz for low-speed recording such as cassette tapes Otherwise same as peak meter |
<Others> | |
Spare module socket Available Options with |
Connecting microphones (such as the Shops CMC series) with a 12-volt phantom power supply Addition of an output buffer amplifier Addition of a low boost circuit |
Pwer | 100 VAC, 50Hz/60Hz |
Power consumption | Approx. 20W |
External dimensions | Body : Width 483x Height 150x Depth 206 mm Power Supply : W 101x H 101x D 256 mm |
Weight | Body : 4.7 kg Power Supply : 2.2 kg |