Marantz SM6100SA
¥ 36,800 (released in 2000)
Commentary
Similar to the SM-17SA, this stereo power amplifier was developed based on the "simple & flexible power amplifier concept".
A current feedback type is used for the power amplifier.
In addition to the direct input, there is also a variable input, the maximum gain of which is set to 29 dB, which is the same as a general AV amplifier.
The direct input has the same gain as the power section of the PM6100SA, so it can be used as a bi-amplifier drive when using a combination.
It is equipped with through output terminal which can be driven simultaneously by stacking multiple units of SM6100SA.
The speaker terminal is made by WBC of Germany.
An inlet type AC cable is used.
.JPG)
Model Rating
| Type | Stereo power amplifier |
| Rated Output (20 Hz to 20 kHz, Both Channel Drive) | 70W + 70W (4 Ω) 60W + 60W (6 Ω) 50W + 50W (8 Ω) |
| Total harmonic distortion factor (20 Hz to 20 kHz, both channel drives) | 0.01% (at 8 Ω load) |
| Intermodulation Distortion Factor (SMPTE) | 0.01% |
| Output Bandwidth (8 ohm load, 0.04%) | 10 Hz to 50 kHz |
| Frequency Response (CD, Source Direct) | 5 Hz to 80 kHz + 0 -1dB |
| Damping factor (20 Hz to 20 kHz) | 100 or More (8 Ω Load) |
| Input Sensitivity / Impedance | Direct input : 1.5V/28k Ω Variable input : 0.7V/33k Ω |
| Signal-to-noise ratio (IHF A network, input short) | Direct input : 110 dB |
| Power supply voltage | 100 VAC, 50Hz/60Hz |
| Power consumption (Electrical Appliance and Material Control Law) | 135W |
| Maximum external dimensions | Width 440x Height 124x Depth 320 mm |
| Weight | 7.5kg |
| Attachment | AC Cable |