LUXMAN SQ606
¥ 39,000 (Released in September 1968)
Commentary
This pre-main amplifier was released as a popular type that allows you to enjoy the sound of Lux more easily.
The basic configuration is the same as that of SQ505. Only the auxiliary circuit of the pre-part has a different structure. In addition, by changing the acceptance criteria of the parts, the configuration is almost the same but the cost is reduced.
Model Rating
Type | Solid state pre-main amplifier | ||||
Continuous output | 30W + 30W (8 Ω) 20W + 20W (16 Ω) |
||||
Distortion factor | 0.1% or Less (10W) 0.2% or Less (30W) |
||||
Frequency characteristic | 20 Hz to 50 kHz - within 1 dB | ||||
Input sensitivity | Phono:2.5mV Tuner:125mV |
||||
Signal-to-noise ratio | Phono:65dB Tuner:70dB |
||||
Damping factor | Approximately 70 (16 Ω, 1 kHz) | ||||
Tone control | NF type bending point switching system | ||||
Residual noise | 1 mV or less | ||||
Accessory circuit | Tape monitor Headphone jack Mode switch (stereo - mono) Attenuator Tone control / defeat switch |
||||
Semiconductor used |
|
||||
Power consumption | 15 VA (No Signal) 120 VA at maximum output |
||||
External dimensions | Width 451x Height 147.5x Depth 268 mm | ||||
Weight | 10kg |