LUXMAN CL35II

Commentary

A bulb-type control amplifier that has been improved to a higher degree of perfection.

The equalizer circuit uses the Marantz type K-K ・ NF method, which uses three stages of 3-pole tubes.
For CL35II, the input withstanding voltage at 1 kHz is 400 mV, and this has been improved by focusing on the input withstanding characteristics in the high sound range of 2 kHz or more.

The intermediate amplifier, tone control stage and cathode follower stage are analyzed to reduce the second and third harmonic distortion at the normal level (output 100 to 300 mV) to ensure linearity.

A cathode follower is used for the output stage.
The CL35II uses a unique method to provide a stable circuit in which the output voltage does not fluctuate against fluctuations in the power supply voltage.

Attention has also been paid to the power supply section to improve the feeding method to the equalizer stage and reduce the contamination of external shock noise.

LUX type NF tone control allows fine adjustment of sound quality by switching the bending point by 3 high and low points respectively.
If you don't use the tone control, you can also use the Defeat switch.

Equipped with high filter and low filter.

Equipped with a low frequency trimmer, it is possible to delicately adjust the frequency characteristics mainly in the 150 Hz to 300 Hz band where the influence of the speaker and the room is remarkable.
This circuit is installed after exiting the equalizer circuit and has no effect on the recording output.

Equipped with an attenuator.

It has a built-in headphone amplifier.

The auxiliary input terminal is equipped with a level set.

Step-up transformer insertion socket is provided on the rear panel, and step-up transformer for MC cartridge can be connected.

Model Rating

Type	Tube type control amplifier
Frequency characteristic	15 hz to 40 khz -1dB
Total harmonic distortion factor	0.06% or Less (Output 2 v)
Output voltage	Maximum 15 v (0.3% strain rate)
Output impedance	550 Ω
Input sensitivity (output 1 V Level Set Max)	Phono1, 2 : 1.2 mV Aux1, 3 : 120 mV (variable) Aux2:120mV Mic:0.5mV
Input impedance	Phono1 : 100k Ω, 50k Ω, 30k Ω Phono2 : 50k Ω Aux1, 3 : 100k Ω Aux2 : 150k Ω Mic : 50k Ω
Signal-to-noise ratio	Phono : 64 dB or more Aux : 77 dB or more Mic : 60 dB or more
Equalizer	RIAA (standard deviation ± 0.3 dB)
Tone control	LUX System NF Type (Capable of Defeat) Low-pass curve point : 150 Hz, 300 Hz, 600 Hz High-frequency bending point : 1.5 kHz, 3 kHz, 6 kHz
Low filter	25Hz/60Hz, -12dB/oct.
High filter	7kHz/12kHz, -12dB/oct.
Low frequency trimmer	100 ~ 300 Hz (± 0.8 dB, 250 Hz)
Attenuator	-20dB
Attachment	Tape monitor circuit Tape dubbing circuit Socket for step-up transformer
Vacuum tube used	12AX7x6 Pieces 12AU7x1 Piece
External dimensions	Width 476x Height 190x Depth 275 mm
Weight	12kg