LUXMAN CL-40
¥ 330,000 (Released in September 1983)
Commentary
This is the first control amplifier in Luxman that uses a GE vacuum tube.
An S. R. P. P. (Shunt Regulated Push-Pull) output circuit is used for the equalizer circuit.
This circuit uses a twin triode 7025/12AX7A with a Takamasu width-ratio, and sets an optimum operating point to improve performance.
The flat amplifier uses a 2-stage direct-coupled differential-amplifier. The first stage uses a twin triode 7028/6BK7B with a Nakamashi ratio, and the second stage uses a twin triode 7026/6CG7 with a low amplification ratio.
The tone control circuit uses the LUX system NF type, which has simple variation characteristics.
In consideration of sound quality, a vacuum tube is also used for the regulator circuit, and by using two transistors together, gain acquisition and sound quality improvement are achieved simultaneously.
Model Rating
Type | Tube type control amplifier |
Output voltage | Pre-out : Rated at 2 V, maximum 20 V or more (distortion factor 0.3%) |
Output impedance | Pre out, Rec out : 500 Ω |
Total harmonic distortion factor | Phono : 0.05% or less (Rec out, 2 v, 1 kHz) Tuner, DAD, Line : 0.05% or less (pre-out, 2 v, 1 khz) Monitor1/2 : 0.05% or less (Pre-out, 2 v, 1 khz) |
Frequency characteristic | Phono : 20 Hz to 20 kHz ± 0.3 dB Tuner, DAD, Line : 1 Hz to 50 kHz ± 0.5 db Monitor1/2 : 1 Hz to 50 kHz ± 0.5 dB |
Input Sensitivity (Output 1 v) | Phono:1.8V Tuner, DAD, Line : 170 mv Monitor1/2:170mV |
Input impedance | Phono : 50k Ω, 100k Ω (with changeover switch) Tuner, DAD, Line : 100k Ω Monitor1/2 : 100k Ω |
S/N ratio (input short, IHF-A correction) | Phono : 75 dB or more Tuner, DAD, Line : 100 dB or higher Monitor1/2 : 100 dB or more |
Tone control | LUX System NF Type Bass, Treble : + / - 7 max. |
Attachment | Low-pass filter (subsonic : 10 hz, low cut : 40 hz) Monitor switches (tape-1, tape-2) Tape Dubbing Switch (1-2, 2-1) Recording switch Mode switch (reverse, stereo, mono) Attenuator (-20dB) Tone in switch Headphone amplifier and jack (8 Ω output : 40 mW) Input Impedance Selector Switch for Phono (50k Ω, 100k Ω) Line phase sensor |
Vacuum tube used | 7025/12AX7A : 3 pieces 7028/6BK7B : 2 pieces 7026/6CG7 : 2 pieces 7030/12AU7A : 1 piece 7032/12BH7A : 1 Piece |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 50W (Electrical Appliance and Material Control Law) |
External dimensions | Width 470x Height 168x Depth 402 mm |
Weight | 8.0kg |