FOSTEX SVA20
¥ 38,000 (1 unit, around 1989)
Commentary
A 2-way active speaker system incorporating a power amplifier into the SV20.
The magnetic circuit uses a repulse type magnetic circuit with very little magnetic leakage to the outside.
This eliminates the impact on cathode ray tubes and other products.
A 13 cm cone type woofer is installed in the low range.
A multi-layer cone unique to Fostex is used for the diaphragm.
A ring-type RP tweeter is installed in the high range.
The enclosure has a unique curvilinear form. It is made of extra-thick special foam molding with a thickness of 5 cm using advanced molding technology. There is no noise or insufficient strength that can be seen with resin molded products.
A bass reflex system is adopted for the internal structure, and a special rubber damper with high anti-vibration ability is installed in the rear part to enable voluminous low sound reproduction.
There was a special speaker stand SF450 sold separately.
This stand can be set to a height of approximately 45 cm from the floor or can be fixed by swinging the speaker from side to side.
Model Rating
Method | Built-in Amplifier / 2-Way / 2-Speaker / Bass reflex ・ Setting-free type ・ Anti-magnetic design |
Units Used | For low band : 13 cm cone type For High Frequency : Ring Type |
Amplifier output | 50W |
Input impedance | 28k Ω |
Input sensitivity | 210mV |
Input terminal | RCA Pin (Line In) |
Frequency characteristic | 90 Hz to 20 kHz |
Output sound pressure level | 86dB/W/m |
Pwer | 100 VAC, 50Hz/60Hz |
Power consumption | 32W |
External dimensions | Width 162x Height 300x Depth 192 mm |
Weight | 5.0kg |
Sold Separately | Speaker Stand SF450 (1 unit, ¥ 6,000) |