Dynavector DV-3000Gold

Commentary

A control amplifier released as a superior model of the DV 3000.

For the DV 3000 Gold, Telefunken high reliability tubes ECC 802 and ECC 803 are carefully selected and used.
All the sockets and input / output terminals of the 10 vacuum tubes are gold-plated to prevent problems caused by contact resistance and increases in contact resistance caused by corrosion.

The front panel uses a 20 mm thick aluminum plate and is finished with an ultra-precision solid plate.
Also, all the knobs are finished with gold plating.

The left and right channels are completely separated electrically and mechanically. As a result, the conventional 40 to 50 dB crosstalk at 10 kHz is reduced to 90 dB or more at 10 kHz or less.

A low-impedance CR circuit is used to minimize the RIAA deviation of the equalizer circuit.
In addition, the DV 3000 Gold is fully DC, which increases the stability of the low-frequency circuit and flattens the characteristics.

The amplifier circuit consists of a direct-coupled amplifier with DC feedback as a basic unit.

A passive CR circuit is used for the tone control circuit and equalizer circuit, which eliminates the phase disturbance in the high-frequency range and the distortion caused by the normal NF type.

It is compatible with both MM and MC cartridges by switching between Phono inputs.

An interstage capacitor with a third harmonic distortion factor of 150 dB or less is used to reduce the low-level signal distortion factor.
All components, including the equalizer, are carefully selected by a Linearity Checker of Radiometer (Denmark).

Balance control is eliminated and channel separation is improved.

It has a direct terminal that can be directly input to the equalizer circuit without passing through the selector.
The muting switch can cut the noise when the needle goes up and down.

The VU meter and peak meter can be switched, and a dimmer switch is installed to change the brightness of the meter light.

There was a special wood case sold separately.

Model Rating

Type	Tube type control amplifier
Input / output terminal	Phono : Route 3, 100k/50k/1k Ω switchable Aux : 2 systems, 100k Ω Tuner : 1 system, 100k Ω Tape : 1 system, 100k Ω Pre out : 2 systems, 600 Ω
Gain	Phono:60dB Aux:20dB
Rated output	Pre out:1V Rec out:100mV
Maximum power output	Pre out : 20 Vrms or more (100k Ω termination) Rec out : 2 Vrms or more (100k Ω termination)
Noise (IHF-A)	Phono : 1.5 μ V or less (input conversion, input short-circuit) Aux : 20 μ V or Less (Input Conversion, Input Short Circuit)
Total harmonic distortion factor	0.2% or Less (Rated Output)
Tone control	Bass : ± 10 dB (100 Hz) Treble : ± 10 dB (10 kHz)
Muting	60 dB or more
Input sensitivity	Phono:1mV Aux:100mV
Maximum allowable input	Phono:600mVp-p Aux:6Vp-p
Meter indication	Rise : 10mm/sec or less Recovery : 0.3 sec or less
Vacuum tube used	ECC803S : 1 Piece ECC802S : 3 pcs
Pwer	90 VAC ~ 115 V, 50Hz/60Hz
Power consumption	100W or less
External dimensions	Width 480x Height 155x Depth 362 mm
Weight	15kg