DENON DP-60M
¥ 82,000 (around 1981)
Commentary
A record player corresponding to the manual machine of DP-60L.
DENON quartz and AC servo motor are used for the rotating system.
Bi-directional servo supports both increase and decrease slave changes. In addition, a smooth electronic brake is built in to prevent the pain of the surface and needle tip.
A straight-type tone arm with an effective mass of approximately 5.5g is used for the tone arm part, and is compatible with high-compliance type cartridges.
It also comes with a universal S-shaped tone arm pipe that can be replaced depending on the cartridge.
Vibration isolation measures are taken by an 80 mm thick armboard.
A laminated cabinet is used for the cabinet.
In addition, the exterior is mirror finished with Bubinga natural wood.
Model Rating
Type | Player system |
Phono Motor Section | |
Drive system | Bidirectional servo direct drive |
Motor | AC servo motor |
Speed control | Two way servo DENON quartz |
Number of revolutions | 33 1/3, 45 rpm |
Wow and flutter | 0.015% W. rms or less (DENON measurement method) 0.02% W. rms or Less (JIS Measurement Method) |
Rotational speed deviation | 0.002% or less |
Speed switching mechanism | Soft Touch Push Button Type (Self-Illumination Type) |
Signal-to-noise ratio | 78 dB or more (DIN-B) |
Startup time | Within 1.5 Seconds (33 1/3) |
Load characteristic | 0% (Needle Pressure 100g Outer Circumference) |
Voltage characteristic | 0% for 90 ~ 110 V |
Brake | Electronic |
Turntable | Aluminum Die Cast 30 cm |
Moment of inertia | 200 kg / cm2(including turntable seats) |
Arm Section | |
Type | Static Balance with Damping / Shell Integrated Structure / Light Mass Straight Type Arm pipe replaceable (S-shaped arm pipe with standard 4P connector and special weight included) |
Effective length | 244mm |
Effective mass at straight arm | 5.5g (excluding cartridge) |
Overhang | 14mm |
Tracking error | 2.5 degrees or less |
Needle pressure control | 1 Rotation 2.5g (1 Scale 0.1g) |
Applicable Cartridge Dead Weight | Straight Type : Approx. 4 ~ 10g (Including Screws) S-shaped : Approx. 12 ~ 18g (Including Shell, etc.) |
Height adjustment | Approximately 4.5 mm |
Output code | Low capacity cord, approx. 1.2m |
Attachment mechanism | Anti-skating mechanism |
<General> | |
Cabinet | Bubinga natural wood 貼鏡 Finish, 20 mm Thick Dense Particle Board |
Pwer | 100 VAC, 50Hz/60Hz |
Power consumption | 11W |
External dimensions | Width 485x Height 180x Depth 410 mm |
Weight | Approx. 13 kg |
Attachment | Tone Arm Pipe (Straight and S-shaped) 1 Each Counterweight |