DENON PMA-9.5
¥ 100,000 (around 1996)
Commentary
Pre-main amplifier of the point component series.
It inherits the philosophy and technology of the S1 series and uses a single push-pull circuit using a high-current amplifier UHC-MOS.
It employs a left and right independent heat sink layout centered on a large power transformer, eliminating interference between left and right channels due to induced current and improving sound quality.
In addition, carefully selected parts are used to achieve higher sound quality.
Equipped with a CD direct switch, the tone control circuit can be eliminated by turning it ON.
It comes with a remote control that can also control DENON CD players and cassette decks.
Model Rating
Type | Pre-main amplifier |
Power Amplifier Unit | |
Rated output | 50W + 50W (20 Hz to 20 kHz, 6 Ω) |
Maximum practical power | 80W + 80W (6 ohm, EIAJ) |
Total harmonic distortion factor | 0.07% (1 kHz, 8 Ω) |
Speaker load impedance | A, B : 6 Ω ~ 16 Ω A + B : 12 Ω ~ 16 Ω |
Preamplifier Section | |
Input Sensitivity / Impedance | Phono MM : 2.5mV/47k Ω Line : 150mV/15k Ω |
Rated output | Rec out:150mV |
RIAA deviation | 20 Hz to 20 kHz ± 0.5 dB |
<General> | |
Signal-to-noise ratio | Phono MM:80dB Line:96dB CD Direct:100dB |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 110W |
External dimensions | Width 250x Height 113x Depth 375 mm |
Weight | 7.2kg |
Attachment | Remote control |