DENON PMA-201SA
¥ 53,000 (Released in September 2001)
Commentary
PRESTA201SA series pre-main amplifier.
The circuit system uses HC (High Current) single push-pull circuit which inherits the concept of UHC single push-pull circuit.
A high-speed rectifier diode and a large high-sound block capacitor are used in the power supply section to support output circuits using HC transistors.
Uses S. L. D.C. (Signal Level Divided Construction).
In this method, the small-signal circuit, large-signal circuit and microcomputer circuit are separated to suppress interference between the circuits.
A source direct circuit is mounted.
When the Source Direct is ON, the Bass, Treble, Loudness and Balance control circuits are bypassed to achieve a simple signal path.
Built-in pre-out terminal.
Equipped with a Rec out selector, it is possible to record behind the scenes such as dubbing from CD to MD while listening to radio broadcast.
It is equipped with a phono equalizer amplifier.
The display has a dimmer function, and the brightness can be changed to 4 levels.
Equipped with a speaker terminal for banana plug.
Comes with a multi-functional remote control for centralized control of the system.
The control dock for iPod can be connected, and the control dock ASD-1R (sold separately) can be connected using the system connector terminal.
You can also use the remote control included with the PMA-201SA for basic iPod operation.
Model Rating
Type | Pre-main amplifier |
Power Amplifier Unit | |
Rated output | 50W + 50W (8 Ω, THD 0.1%) |
Maximum practical power | 100W + 100W (4 Ω, JEITA) |
Total harmonic distortion factor | 0.01% (8 ohm at -3dB rated output, 1 khz) |
Speaker load impedance | AORb : 4 Ω ~ 16 Ω A + B : 8 Ω ~ 16 Ω |
Preamplifier Section | |
Input Sensitivity / Impedance | Phono MM : 2.5mV/47k Ω Line : 150mV/15k Ω |
Rated output | Rec out:150mV |
RIAA deviation | 20 Hz to 20 kHz ± 0.5 dB |
Preamplifier Section | |
Input Sensitivity / Impedance | Line : 100mV/16k Ω Phono MM : 2.5mV/47k Ω |
RIAA deviation | 20 Hz to 20 kHz ± 0.5 dB |
<General> | |
Signal-to-noise ratio | Phono MM : 83 dB at 5 mV input Line : 104 dB (when input terminal is short-circuited) |
Frequency characteristic | 5 Hz ~ 100 kHz + 0 -3dB |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 135W Standby power : 1W or less |
External dimensions | Width 250x Height 90x Depth 371 mm (including foot, knob and terminal) |
Weight | 6.1kg |
Attachment | Dedicated System Remote Controller (RC-906) |