Aurex SB-260
¥ 37,800 (around 1970 s)
Commentary
A pre-main amplifier that adopts a pure complimentary service OCL circuit directly connected to all stages.
A low-noise transistor and resistor improve the SN ratio of the preamplifier section.
Equipped with a loudness switch.
Equipped with a wide range power meter.
Mixing recording is possible by using the separately sold microphone mixing amplifier MX-1.
Model Rating
Type | Pre-main amplifier |
Circuit system | All-stage direct-coupled complimentary service OCL circuit |
Semiconductor used | Transistor : 24 Diode : 23 Pieces |
Preamplifier Section | |
Input Sensitivity / Impedance | Phono : 2.5mV/47k Ω Tuner, AUX, Tape Play : 150mV/47k Ω |
Recorded output | Tape Rec:150mV |
Equalizer | Allowable Input : 170 mV (Distortion 0.3%) (RMS) RIAA deviation : ± 0.5 dB at 30-15 kHz |
Bass Control | 100 Hz ± 10 dB |
Treble Controls | 10 kHz ± 10 dB |
Loudness | + 10 dB (100 Hz), + 3 dB (10 kHz) (at -40dB from maximum volume) |
Signal-to-noise ratio | Phono:70dB AUX, Tape : 90 dB |
Power Amplifier Unit | |
Continuous Output (1 khz, 2 ch Drive) | 42W + 42W (8 Ω) 47W + 47W (6 Ω) |
20 Hz ~ 20000 Hz Output (2 ch Drive) | 40W + 40W (8 Ω) 45W + 45W (6 Ω) |
Harmonic output (continuous output) | 0.3% or less At 4W output : 0.05% or less |
Intermodulation distortion factor (at continuous output) | 0.3% or less |
Output Bandwidth (IHF) | 5 Hz to 40 kHz |
Frequency characteristic | 5 Hz to 70 kHz ± 1 dB |
Damping factor | 25 |
Residual noise | 0.7 mv or Less (8 Ω) |
Load (impedance) | 6 ~ 16 Ω |
<General> | |
Pwer | AC100V 50Hz/60Hz |
Outlet | 1 linked, 1 non-linked |
Power consumption | 85W |
External dimensions | Width 400x Height 146x Depth 305 mm |
Weight | 7.8kg |