SANSUI TAC-505
¥ 59,000 (around 1971)
Commentary
A stereo receiver developed by inheriting the development policy of the PB series.
The front-end of the FM tuner section uses an FET and an ultra-precision 3-row linear varicon to obtain high sensitivity and stability. In particular, various RF characteristics such as distortion factor and capture ratio are improved.
In addition, the 4-stage IF amplifier and 3-stage limiter circuit provide a sufficient limiter effect, enabling stable FM broadcasting even in noise-prone areas and low-power areas.
The tuner panel has a unique round dial that floats on the green.
It also has two FM antenna terminals and a high-sensitivity ferrite bar antenna for AM.
A quasi complimentary service SEPPP OTL circuit is used for the main amplifier.
Low-noise silicon transistors are used in the equalizer circuit, and all-stage silicon transistors are used in the low-frequency section to improve the signal-to-noise ratio and achieve low distortion.
There are two Phono inputs.
The tone control section is equipped with Klix/Klukš top-style triple tone control, so you can adjust not only general low and high range but also middle range.
It is equipped with functions such as high and low filter, loudness control, mode switch, tape monitor circuit and headphone terminal.
Model Rating
Type | FM/AM Receiver | ||
Power Amplifier Unit | |||
Effective power | 20W/20W (4 Ω) 18W/18W (8 Ω) |
||
Music Power (IHF) | 50W (4 Ω) 42W (8 Ω) |
||
Total harmonic distortion factor | Not more than 0.5% | ||
Power Band With | 30 Hz to 30 kHz | ||
Frequency characteristic | 25 Hz to 40 kHz ± 1 dB | ||
Hum and noise (IHF) | 100dB | ||
Input Sensitivity / Impedance | 0.8V/100k Ω | ||
Damping factor | 30 (8 Ω) | ||
Preamplifier Section | |||
Total harmonic distortion factor | Not more than 0.1% | ||
Output voltage | 2 V (maximum output) 0.8 V (Rated Output) |
||
Frequency characteristic | 20 Hz to 30 kHz ± 1 dB | ||
Hum and noise (IHF) | Phono:65dB Aux:70dB |
||
Input Sensitivity / Impedance (rated input, 1 kHz) |
Phono1, 2 : 2mV/50k Ω Aux : 170mV/100k Ω Tape Mon (pin) : 150mV/100k Ω Tape Recorder (din) : 150mV/100k Ω |
||
Recorded output | Tape rec(pin):150mV Tape recorder(din):30mV |
||
Tone control | Bass : ± 12 dB (20 Hz) Midrange : ± 5 dB (1,5 kHz) Treble : ± 12 dB (20 kHz) |
||
Loudness | 50Hz:+8dB 10kHz:+3dB |
||
High filter | -10dB(10kHz) | ||
Low filter | -10dB(50Hz) | ||
Tuner Section | |||
Sensitivity |
|
||
Selectivity | FM:32dB AM:20dB |
||
IF Rejection | FM:70dB AM:60dB |
||
FM capture ratio | 3dB | ||
FM S/N ratio | 60dB | ||
FM total harmonic distortion factor | 1% | ||
<Others> | |||
Power consumption | 135W | ||
External dimensions | Width 455x Height 127x Depth 298 mm | ||
Weight | 8.85kg |