SANSUI SAX-350D
¥ 54,900 (around 1971)
Commentary
This stereo receiver was developed for the full-scale stereo era and for enjoying Hi-Fi with ease.
The FM front-end uses an FET and a frequency linear 3-row variable capacitor to improve stability.
The 4-stage IF amplifier and 3-stage limiter circuit provide sufficient limiter effect.
The output circuit uses the quasi complimentary service SEPPP OTL system.
A low-noise silicon transistor is used in the preamplifier section.
Equipped with two FM antenna input terminals of 300 Ω and 75 Ω, and an FM input selector switch.
The FM tuner section is equipped with a new type noise canceller.
Equipped with a tape monitor, loudness control, headphone jack, FM stereo indicator, MPX noise canceler, AM ferrite bar antenna, tuning meter, etc.
Model Rating
| Type | FM/AM Receiver |
| Amplifier Unit | |
| Effective power | 22W/22W (4 Ω) 20W/20W (8 Ω) |
| Music Power (IHF) | 54W (4 Ω) 46W (8 Ω) |
| Total harmonic distortion factor | 1% |
| Power Band With | 30 Hz to 30 kHz |
| Frequency characteristic | 30 Hz to 30 kHz |
| Damping factor | 45 |
| Hum and noise | Phono:65dB Aux:70dB |
| Input sensitivity | Phono:2.2mV Aux, Tape Mon (Pin/Din) : 150 mv |
| Recorded output | Tape rec(Pin):150mV Tape rec(Din):30mV |
| Tone control | Bass : ± 10 dB (50 Hz) Treble : ± 10 dB (10 kHz) |
| Loudness | 50Hz:+8dB 10kHz:+3dB |
| Tuner Section | |
| Sensitivity | FM (20 dB) : 2.5 μ V FM (IHF) : 3 μ V AM : 350 μ V |
| Selectivity | FM:32dB AM:20dB |
| IF Rejection | FM:70dB AM:55dB |
| FM capture ratio | 3dB |
| FM S/N ratio | 60dB |
| FM total harmonic distortion factor | 1% |
| <Others> | |
| Power consumption | 135W |
| External dimensions | Width 414x Height 144x Depth 305 mm |
| Weight | 9.5kg |