ROTEL RX-150A
¥ 29,800 (around 1973)
Commentary
This is a low-cost stereo receiver that has the performance of one class.
A high-sensitivity FET is used for the FM front end.
It is possible to switch the connection of two speaker systems.
Equipped with a tape monitor function.
Built-in 4-channel speaker matrix.
Model Rating
Type | FM/AM stereo receiver |
<Audio section> | |
Music Power (IHF) | 37W (4 Ω) 23W (8 Ω) |
Effective power | 8W/8W (8 Ω) |
Harmonic distortion factor | 0.35% or Less (at Rated Output) |
Intermodulation distortion factor (70 hz : 7 khz = 4 : 1) | Not more than 1% |
Frequency characteristic | 14 Hz ~ 50 kHz + 0 -3dB |
Output band characteristic | 35 Hz to 30 kHz |
Damping factor | 15 or more |
Signal-to-noise ratio | Phono:60dB Aux:70dB |
Residual noise | 1mV |
Input Sensitivity / Impedance | Phono : 2.2mV/45k Ω X-tal : 100mV/190k Ω Aux : 250mV/125k Ω |
Tone control | Bass : + 14 dB ~ -11.5 dB Trebel : + 11 to -14dB |
FM Tuner Section | |
Antenna impedance | 300 Ω equilibrium |
Sensitivity (IHF) | 3.5 μ V |
Harmonic distortion factor (400 Hz, 100% modulation) | mono:0.7% stereo:1.5% |
Signal-to-noise ratio | 60dB |
Image interference ratio | 50dB |
Spurious response | 70dB |
Intermediate frequency interference ratio | 70dB |
Capture ratio | 8dB |
Selectivity (IHF) | 25dB |
Separation | 35dB(1kHz) |
SCA suppression ratio | 60dB |
AM suppression ratio | 40dB |
<AM Tuner Section> | |
Practical sensitivity | 30 μ V (S/N = 20 dB) |
Image Ratio (1 mhz) | 35dB |
Intermediate frequency interference ratio (1 MHz) | 35dB |
Signal-to-noise ratio | 45dB |
<General> | |
Semiconductor used | Transistor : 28 Diode : 27 units |
Power consumption | 70VA |
External dimensions | Width 414x Height 130x Depth 175 mm |
Weight | 4.5kg |