Audio Database

Image of SX-90
Commentary

A total stereo amplifier developed in pursuit of higher quality by IC and best-in-class power.

The FM front-end section is composed of a low-noise FET and a four link varicon.
The IF and MPX circuits are integrated into highly reliable ICs.

The tuner meters are equipped with a signal strength meter and a center tuning meter to enable more accurate tuning.

Equipped with a Low/High filter.

Equipped with Route 3 speaker outputs and center channel outputs.

It has a mixing circuit that can mix a microphone with other sources.

In consideration of upgrading to a multi-amplifier system, the pre-part and main part can be separated.

Model Rating
Solid-state integrated stereo amplifier
Tuner Section
Receiving sensitivity FM : 1.8 μ V
AM : 10 μ V (IHF)
Receiving band FM : 76 MHz to 90 MHz
AM : 535 kHz to 1,605 kHz
Capture Ratio (IHF) 0.7dB(82MHz)
Antenna input FM : 300 Ω balanced
Circuit type (FM) Double-tuned front-end with high-frequency amplification using FET and 4-series varicon
Multi-circuit with 4-IC IF amplification, ratio detection, monolithic IC
Accessory circuit Signal strength meter for AM/FM common use
Center tuning meter
Stereo indicator
Muting switch
SCA Filters
Ferrite antenna
Amplifier Unit
Circuit system SEPP-OTL, quasi complimentary service circuit
Music power 145W (8 ω, 0.5% Distortion, IHF)
Continuous Rated Output (Both Channel Operation) 38W + 38W (8 Ω)
Output bandwidth 15 Hz ~ 40 kHz (Constant Distortion Rate 0.5%, IHF)
Input Sensitivity / Impedance Phono MAG : 2.7mV/50k Ω
Phono Xtal/CER : 60mV/100k Ω
MIC : 3.2mV/30k Ω
Tape Monitor : 200mV/100k Ω
Main in : 480mv/80k Ω
Signal-to-noise ratio MAG:80dB
Aux : 100 dB or more
Output terminal Speaker jacks : Route 3 (A, B, C switchable), 4 Ω ~ 16 Ω
Stereo headphone jack
Tape rec connector
Pre out:480mV
Center Channel Output Terminal : 500 mv
DIN standard recording and re-connector
Accessory circuit Tone Controls (Bass, Treble)
Low/High Filter
Loudness contour
Microphone mixing
Premain split switch
<General>
Semiconductor used Transistor : 41
FET : 1
IC : 5
Diode : 19 units
Power supply voltage 100 VAC, 50Hz/60Hz
Power consumption 250VA
External dimensions Width 459x Height 145x Depth 369 mm
Weight 11.4kg