Pioneer A-UK3II
¥ 45,000 (released in 1997)
Commentary
This is a pre-main amplifier that inherits the design philosophy of A-UK3 with simple and straight design and further refines the sound quality.
It omits all the attached functions and does not include tone control, balance control, or headphone jacks.
This simplifies result, the signal path and circuit layout are simplified and higher purity sound is sought.
Equipped with a wide-range linear circuit, it acquires stable driving power over a wide range.
Speaker terminal compatible with banana plug is adopted.
An inlet type power cord is used, and a 3-core cable with ground is used.
Model Rating
Type | Pre-main amplifier |
Rated Output (Both channel drive) | 60W + 60W (4 ohm, 20 hz to 20 khz, 0.05%) 30W + 30W (8 ω, 20 Hz-20 kHz, 0.03%) |
Damping factor | 130 (20 Hz ~ 20 kHz, 8 Ω) |
Input Sensitivity / Impedance | Phono MM : 2.8mV/50k Ω CD, Tuner, Line, DAT/Tape1, Tape2 : 200mV/40k Ω |
Phono maximum allowable input | Phono MM : 150 mV (1 kHz, 0.1%) |
Output Level / Impedance | DAT/Tape1, Tape2, Line, Rec, Adaptter out : 200mV/1k Ω |
Frequency characteristic | Phono MM : 20 Hz to 20 kHz ± 0.3 dB CD, Tuner, Line, DAT/Tape1, Tape2 : 1 Hz to 300 kHz + 0 -3dB |
Signal-to-noise ratio (IHF-A network Short circuit) |
Phono MM:86dB(2.8mV) CD, Tuner, Line, DAT/Tape1, Tape2 : 110 dB |
Speaker load impedance | 4 Ω ~ 16 Ω |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 130W (Electrical Appliance and Material Control Law) |
External dimensions | Width 420x Height 126x Depth 352 mm |
Weight | 7.3kg |