Pioneer A-01
¥ 26,800 (released in 1995)
Commentary
Pre-main amplifier with wide-range technology.
It is equipped with a wide-range linear circuit developed for stable amplification of input signals from digital devices.
This circuit is a simple circuit for obtaining the gain required by a single-stage amplifier circuit. It has excellent current linearity and flat output impedance from low to high range.
In addition, the triple-feedback system realizes high stability even in the high-frequency range, improving the ability to reproduce minute sounds and driving the speakers over a wide range with sufficient space.
The low-load drive design improves the drive performance of the speakers at low loads, enabling stable playback from low to high frequencies.
It employs a highly rigid wing chassis that effectively disperses and attenuates vibration from the power transformer.
It effectively eliminates vibration from the transformer to the wing shape at the bottom of the chassis and from the directly connected insulator to the outside of the amplifier.
In order to simplify the signal path as much as possible, the function switch is laid out in the shortest position at the signal input section.
In addition, by switching the direct switch, switches and circuits such as balance, tone control circuit and loudness circuit can be bypassed, and input directly to the power amplifier section.
Round shape is used for the front panel.
Equipped with Route 6 audio input.
In addition, Tape1 and 2 support mutual dubbing.
A large speaker terminal is used to prevent transmission loss and provide a stable current supply.
Model Rating
Type | Stereo pre-main amplifier |
Maximum Practical Power (EIAJ) | 70W + 70W (4 Ω) |
Rated output (both channels driven) | 40W + 40W (4 ohm, 20 hz to 20 khz, 0.1%) 35W + 35W (8 ω, 20 Hz-20 kHz, 0.07%) |
Input Sensitivity / Impedance | Phono MM : 2.8mV/50k Ω CD, Tuner, Line, Tape1/DAT, Tape2 monitor : 200mV/50k Ω |
Phono maximum allowable input | MM : 150 mV (1 kHz, 0.1%) |
Output Level / Impedance | Tape1/DAT, Tape2 monitor : 200mV/1k Ω |
Frequency characteristic | Phono MM : 20 Hz to 20 kHz ± 0.5 dB CD, Tuner, Line, Tape1/DAT, Tape2 monitor : 5 Hz to 100 kHz + 0 -3dB |
Tone control | Bass : ± 8 dB (100 Hz) Treble : ± 8 dB (10 kHz) |
Loudness contour (VR-30dB) | + 5 dB (100 Hz), + 3 dB (10 kHz) |
Signal-to-noise ratio (IHF, A-network Short circuit) |
Phono MM:77dB(2.8mV) CD, Tuner, Line, Tape1/DAT, Tape2 monitor : 105 dB |
Speaker load impedance | A, B : 4 Ω ~ 16 Ω A + B : 8 Ω ~ 32 Ω |
AC outlet | Power Switch Interlock : 2 Systems (100W) Power switch not linked : 1 system (100W) |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption (Electrical Appliance and Material Control Law) | 105W |
External dimensions | Width 420x Height 110x Depth 312 mm |
Weight | 5.2kg |