ONKYO Integra T-466NII
¥ 49,000 (released in 1975)
Commentary
An FM/AM tuner designed with an emphasis on basic performance.
A low-noise FET and a frequency-linear four link varicon are used in the front-end section to achieve 1.9 μ V (IHF) interference rejection characteristics.
In addition, the Narrow-type AFC circuit, which increases frequency stability, is combined with the use of a local variable capacitor and detector, which are less affected by temperature and humidity drift, to prevent tuning deviation.
A linear-phase-type ceramic filter and a differential-type IC are used in the IF section to obtain sufficient limiter effect.
The MPX section uses a PLL circuit that is less susceptible to degradation due to temperature and humidity. It is combined with a low-pass filter that improves internal separation to improve separation.
The tuning mechanism is the same as that of the T-455NII.
Equipped with a multi-path output terminal that is convenient for determining antenna position.
Equipped with a 4-ch detection output terminal capable of supporting FM4ch broadcasting.
Outputs are equipped with a Route 3 of level variable / level fixed and DIN terminals.
A triple tune filter is used in the IF stage of the AM part to increase the selectivity.
Model Rating
Type | FM/AM Tuner |
FM Tuner Section | |
Receiving frequency | 76 MHz to 90 MHz |
Sensitivity | 1.9 μ V (IHF) 3.3 μ V (S/N50dB) |
Image ratio | 100dB(83MHz) |
IF interference ratio | 100dB(83MHz) |
Signal-to-noise ratio (IHF) | 73dB |
Spurious interference ratio | 100dB |
2-signal selectivity (± 400 kHz detuning) | 65dB |
AM suppression ratio | 53dB |
Capture ratio | 1.5dB |
Strain Rate (400 Hz) | mono:0.2% stereo:0.4% |
Frequency characteristic | 20 Hz ~ 15000 Hz + 0 -3dB |
Antenna impedance | 75 Ω, 300 Ω |
Stereo separation | 1kHz:40dB 100 Hz to 10 kHz : 35 dB |
Carrier leak | -65dB |
Output voltage (400 Hz, 100% modulation) | Variable : 0 v ~ 1.5 v Fixed : 660 mV |
Output impedance (at maximum variable output) | 5k Ω |
<AM Tuner Section> | |
Receiving frequency | 535 kHz to 1605 kHz |
Sensitivity | 200 μ V/m (bar antenna) |
Image interference ratio | 50dB(1MHz) |
IF interference ratio | 33dB(1MHz) |
Signal-to-noise ratio | 60dB |
Distortion factor | 0.5%(400Hz) |
Output Voltage (400 Hz, 30% Modulation) | Variable : 0 mv ~ 450 mv Fixed : 200 mV |
<General> | |
Semiconductor used | IC : 2 Transistor : 27 Pieces (FET : 2 Pieces) Diode : 17 pcs |
Pwer | 100 VAC, 50Hz/60Hz |
AC Output | Unswitched : 1 line (200 VA) |
Power consumption (Electrical Appliance and Material Control Law standard) | 17W |
External dimensions | Width 467x Height 161x Depth 383 mm |
Weight | 8.4kg |