Marantz PM6100SA ver.2
¥ 43,000 (released in 2003)
Commentary
Based on the PM6100SA, this pre-main amplifier has been improved by introducing Absolute SA Technology which reviews parts, power supply and wiring.
A current feedback type preamplifier is used in the preamplifier section to achieve low noise and high slew rate.
We are also working to improve sound quality by using high-quality electrolytic capacitors.
A current feedback type power amplifier is used for the power amplifier section, and an audio transistor LAPT is used for the power device.
In Ver. 2, a Schottky barrier diode is installed in each rectifying circuit of the power supply.
Each circuit uses high-quality polypropylene capacitors and low-noise metal-coated resistors.
In addition, the fluctuation of potential is eliminated by reviewing the ground potential while repeatedly examining the sound quality.
A speaker terminal made by WBT of Germany is used for the speaker terminal.
Equipped with a full Rec selector with Rec buffer.
Equipped with a phono equalizer amplifier compatible with MM cartridges.
An inlet type AC jack is adopted.
Bi-amp drive is also possible in combination with SM6100SA ver. 2.
It comes with a wireless remote controller that can control Marantz products such as CD7300.
Model Rating
Type | Pre-main amplifier |
Rated Output (20 Hz to 20 kHz, Both Channels Driven Simultaneously) | 70W + 70W (4 Ω) 60W + 60W (6 Ω) 50W + 50W (8 Ω) |
Total harmonic distortion factor (20 Hz to 20 kHz, both channels driven simultaneously, 8 Ω) | 0.01% |
Intermodulation Distortion Factor (SMPTE) | 0.01% |
Output Bandwidth (8 ohm load, 0.04%) | 10 Hz to 50 kHz |
Frequency Response (CD, Source Direct) | 5 Hz ~ 60 kHz + 0 -1dB |
Damping factor (8 Ω, 20 Hz to 20 kHz) | 100 |
Input Sensitivity / Impedance | Phono MM : 2.3mV/47k Ω High Level : 200mV/15k Ω |
Phono maximum allowable input (1 kHz) | MM:130mV |
RIAA deviation (20 Hz to 20 kHz) | + / - 0.2 dB |
S/N (IHF A network, input short) | Phono MM:85dB High Level:110dB |
Tone control | Bass : ± 8 dB (100 Hz) Treble : ± 8 dB (10 kHz) |
Input terminal | Line : Route 3 (CDs, Tuners, Aux / DVDs) MD or Tape system : 1 system CD-R : 1 system Phono : Route 1 |
Output terminal | Pre-out : 1 line MD or Tape system : 1 system CD-R : 1 system One speaker system Headphone : 1 system |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption (Electrical Appliances and Materials Safety Law) | 135W |
Maximum external dimensions | Width 440x Height 124x Depth 340 mm |
Weight | 7.5kg |
Attachment | Wireless Remote Control AC Cable |