LUXKIT A3300
¥ 45,000 (released in February 1972)
¥ 45,800 (around 1974)
Commentary
This tube type preamplifier kit was announced simultaneously with the launch of the LUX KIT brand.
The equalizer circuit is similar to the circuit used in the C-22 Macintosh, and consists of a combination of a P-K / NF circuit (feedback from the second stage plate to the first stage cathode) and a cathode follower circuit.
An orthodox circuit is used to adjust sound quality.
The low-cut filter is CR1-stage type, the high-cut filter is NF-type, and the tone control is Lux-type NF-type with less waviness at the mid-point. The tone control can be adjusted more precisely because the bending point frequency can be switched.
Equipped with an attenuator that can attenuate the gain by 20 dB.
It is equipped with a pure complimentary service type headphone amplifier composed of 4 transistors.
This circuit automatically switches the output of the pre-section to the headphone amplifier when the headphone is inserted.
A3300 does not have a built-in power supply.
For this reason, a special power supply or a power amplifier such as A3500/A2500 is required.
Model Rating
Type | Tube type control amplifier kit |
Output voltage | Rating : 2 V (Distortion Factor 0.08% or Less) Maximum : 15 v (0.5% strain rate) |
Output impedance | 950 Ω |
Total harmonic distortion factor | 0.08% or Less (Output 2 v) |
Frequency characteristic | 20 Hz to 20 kHz -0.5 dB |
Input Sensitivity / Input Impedance (at 1 V output) |
Phono1, 2 : 1.8mV/47k Ω Aux1, 2, 3 : 130mV/150k Ω |
Signal-to-noise ratio | Phono1, 2 : 60 dB or more Aux1, 2, 3 : 77 dB or more |
Tone control | LUX System NF Type with Bending Point Switching Low-range bending point : 250 Hz, 500 Hz High-frequency curve point : 2.5 kHz, 5 kHz |
Filter | Low-cut : 70 Hz (-6dB/oct.) High Cut : 6 kHz (-6dB/oct.) |
Attachment | Headphone amplifier (output 50 mw) Tape monitor circuit |
Vacuum tube used | 12AX7x4 12AU7x2 |
Semiconductor used | 2SC735x4 2SA562x4 KB265x2 |
Power supply part | External power supply system A33 power supply or A3500/A2500 |
External dimensions | Width 400x Height 130x Depth 245 mm |
Weight | 3.5kg |
Sold Separately | Dedicated Power Supply A33 (¥ 7,900) Assembly Manual (¥ 500) |