LUXKIT A3032
¥ 88,000 (Released in November 1976)
Commentary
Preamplifier kit incorporating LUXMAN tube control amplifier CL32 into a kit.
The equalizer amplifier section uses a 3-stage cathode-cathode NF circuit incorporating SRPP (Shunt Regulated Push-Pull) output circuit and feeds back from the output stage to the first stage cathode. This circuit realizes high input resistance and high S / N ratio while keeping distortion factor low.
A two stage plate-cathode NF circuit is adopted for the flat amplifier section. Feedback is applied from the second stage cathode to the first stage plate. Local feedback is applied between the plate and plate to improve the bare characteristics before applying the major NF.
A cathode follower circuit is used for the output stage.
A 4-channel volume has been adopted to improve the SN ratio at a practical level.
A new type of low-frequency filter is used to cut the very low frequencies from 5 Hz to 10 Hz without increasing the number of active elements and minimizing the influence on the audible frequency band.
By eliminating most of the shielding wires in the signal path and routing the input circuit in the shortest path, long-term stability and excellent characteristics are ensured.
A power transformer using a cut core is used for the power supply part, and a DC ignition using a constant voltage circuit is used for the heater power supply to prevent mixing of pulse noise.
Crosstalk characteristics have been improved by separating the vacuum tubes except for the cathode follower of the output stage to the left and right.
There was a muting circuit kit as an optional item sold separately.
This kit allows you to disconnect the output circuit until the operation is stable.
Model Rating
Type | Tube type control amplifier kit |
Output voltage | Rating : 2 v Maximum : 15 V (Distortion Factor 0.3% or Less) |
Output impedance | Pre out : 600 Ω Rec out : 560 Ω |
Total harmonic distortion factor | 0.03% or Less (Output 2 V, 20 Hz to 15 kHz) |
Frequency characteristic | 10 Hz to 40 kHz - within 1 dB |
RIAA deviation | 30 Hz to 15 kHz ± 0.5 dB or less |
Crosstalk | -65dB or less |
Input Sensitivity (Output 1 v) | Phono1, 2 : 2 mV Tuner, Aux2 : 160 mv ~ 5 v (variable) Aux1:160mV |
Input impedance | Phono1 : 30k Ω ~ 50k Ω ~ 100k Ω Phono2 : 50k Ω Aux1 : 200k Ω Tuner, Aux2 : 100k Ω |
Signal-to-noise ratio (IHF-A corrected) Input short) |
Phono : 80 dB or more Tuner, Aux : 95 dB or higher |
Phono allowed input | 560 mV or More (1 kHz, RMS) |
Attachment | Linear equalizer Ultra low pass filter Two tape monitors Tape dubbing Input impedance adjustment for Phono1 Input level set for Tuner and Aux2 Attenuator Output Selector Other |
Vacuum tube used | 12AX7/ECC83x5 12AU7/ECC82x2 |
Pwer | 100 VAC, 50Hz/60Hz |
Power consumption | 40W |
External dimensions | Width 438x Height 77x Depth 322 mm |
Weight | 5.7kg |
Sold Separately | Muting Circuit Kit OP3032 (¥ 2,500) |