LUXMAN SQ505
¥ 58,000 (released in July 1968)
Commentary
LUX's third transistor pre-main amplifier released after SQ77T and SQ301.
While the SQ77T and SQ301 are related to tube amplifiers, the SQ505 was developed with a head-on approach to transistors without being aware of tubes.
There is no difference except that the output is slightly smaller than SQ301 and some accessories (D. F switching, filter for 3D) are omitted. A quasi complimentary service SEPPP OTL circuit is used for the circuit.
Equipped with a low-boost switch, input impedance change-over switch, and attenuator switch.
Model Rating
Type | Solid-state integrated amplifier | ||||
Power Amplifier Unit | |||||
Continuous output | 40W/40W (4 Ω) 30W/30W (8 Ω) 20W/20W (16 Ω) |
||||
Music power | 40W (8 Ω) | ||||
Total harmonic distortion factor | 0.1% or Less (10W) 0.2% or Less (30W) |
||||
Frequency characteristic | 10 Hz to 50000 Hz -1dB | ||||
Input sensitivity | 1 V (30W, 8 Ω) | ||||
Input impedance | 50k Ω | ||||
Residual noise | 0.5 mV or less | ||||
Damping factor |
|
||||
Attenuator | -12dB | ||||
Preamplifier Section | |||||
Frequency characteristic | 20 Hz to 50,000 kHz -2dB | ||||
Total harmonic distortion factor | 0.1% or Less (1 kHz, 1 V) | ||||
Residual noise | 100 μ V or less | ||||
Crosstalk | Between channels : 55 dB or more Between input types : 70 dB or more |
||||
Output Level / Impedance | Pre Out : 1V/100 Ω or less Rec Out : 100mV/100 Ω or less DIN : 50mV/75k Ω |
||||
Input Sensitivity / Impedance (Output 1 v) |
Tape (9.5 cm) : 2mV/150k Ω Tape (19 cm) : 2.2mV/150k Ω Phono1 : 2mV/50k Ω Phono2 : 2mV/30k Ω, 50k Ω, 100k Ω AUX1 : 100 mV or More / 75k Ω ~ 100k Ω AUX2 : 600mV/100k Ω Tape Monitor : 350mV/100k Ω DIN : 350mV/100k Ω |
||||
Maximum Allowable Input (1 kHz) | Tape Head:80mV Phono:80mV AUX1 : 5 V or more AUX2:30V |
||||
Signal-to-noise ratio (volume max) | Tape Head : 60 dB or more Phono : 60 dB or more AUX : 70 dB or more Tape Monitor : 70 dB or higher DIN : 70 dB or more |
||||
Equalizer | Tape Head (9.5 cm, 19 cm) : NARTB Phono:RIAA |
||||
Tone control | LUX System NF Model, Turnover / Roll-off Frequency Switching Type Bass : 600 Hz, 300 Hz, 150 Hz, Defeat Treble : 1.5 kHz, 3 kHz, 6 kHz, Defeat |
||||
Filter | Low Filter : 100 Hz, 6dB/oct. High Filter : 5 kHz, 6dB/oct. |
||||
Low boost | 80 Hz, 6dB/oct. | ||||
<General> | |||||
Attachment | Tape monitor switch DIN connector |
||||
Semiconductor used |
|
||||
Power supply voltage | AC100V | ||||
Power consumption | No signal : 15 VA (12W) Maximum output : 120 VA (100W) |
||||
External dimensions | Width 451x Height 147.5x Depth 268 mm | ||||
Weight | 10.5kg |