LUXMAN L-505u
Blaster White : ¥ 225,750 (released in July 2007)
Champagne Gold : ¥ 225,750 (limited color, sold in August 2007)
Commentary
Pre-main amplifier announced as Ultimate edition of the L-505 series.
Only the distortion component is fed back from the output of the amplifier circuit, and a unique amplifier period circuit ODNF is adopted that achieves a fast initial slew rate and ultra-wide bandwidth.
The L-505u uses the latest version 2.2 with parallelized input stages as a power amplifier.
The power supply uses a high-capacity (400 VA) EI power transformer and a Schottky barrier diode with high conversion efficiency to DC voltage.
The C-1000f, the flagship model of the preamplifier, is equipped with a selector switch IC that is used as an attenuator switch for the volume adjustment mechanism LECUA. This reduces the deterioration of sound quality caused by the input switching circuit, and improves separation and crosstalk characteristics.
The original OFC wire is used for the main part of the power supply and signal system, and glass fiber boards with high rigidity are used for all circuit blocks. In addition, Luxman original custom parts made by repeated trial listening are used to improve sound quality.
The front panel is equipped with a separate switch, allowing for separation of power and pre-power.
Available in two color variations : Blaster White with a large power meter shining blue, and champagne Gold (limited color) with a large power meter shining yellow.
Model Rating
Type | Pre-main amplifier |
Continuous effective output | 140W + 140W (4 Ω) 100W + 100W (8 Ω) |
Input | Line 4 system Phono 1 System (MM/MC Switching) Balance line 1 system |
Recording input / output | Line 2 system |
Pre-output and main input | 1 system each |
Speaker output | Routes A and B2 |
Amplifier circuit | ODNF2.2 |
Output configuration | Bipolar parallel PP |
Power transformer | EI Type 440 va |
Total harmonic distortion factor | 0.005% or Less (8 Ω, 1 kHz) 0.03% or Less (8 Ω, 20 Hz to 20 kHz) |
Input Sensitivity / Impedance | Phono MM : 2.5mV/47k Ω Phono MC : 0.3mV/100 Ω Line : 180mV/42k Ω Bal. Line : 180mV/79k Ω Main in : 1V/51k Ω |
Output voltage | Recorder:180mV Pre out:1V |
S/N ratio (IHF-A) | Phono MM : 91 dB or more Phono MC : 75 dB or more Line : 105 dB or more |
Frequency characteristic | Phono : 20 Hz to 20 kHz ± 0.5 dB Line : 20 Hz to 100 kHz + 0 -3.0 dB |
Damping factor | 110 |
Tone Control Maximum Change | Bass : ± 10 dB (100 Hz) Treble : ± 10 dB (10 kHz) |
Attachment | Front Panel Side Power meter Headphone jack Fono MC Recording selector Speaker selector Mode selector Tone control Balance Straight Line Subsonic Separate Rear Panel Side Balanced phase inverter Line phase sensor AC inlet |
AC outlet | Non-Interlock : 2 systems, total maximum 300W |
Power supply voltage | 100 VAC, 50Hz/60Hz |
Power consumption | 210W (Electrical Appliances and Materials Safety Act) 82W (no signal) 1.2W (standby) |
External dimensions | Width 467x Height 179x Depth 437 mm |
Weight | 21.0kg |
Attachment | Remote control Power Cable (JPA-10000) |