DENON DSW-11R

Commentary

Active subwoofer with LF Direct circuitry.

The unit is equipped with 16 cm cone type woofer.
In order to realize regeneration with excellent linearity even at high output, a special rubber edge with excellent damping effect is adopted.

It has an LF Direct circuit that can pass through the subwoofer's crossover and level control circuits.
This reduces phase distortion and signal degradation on the subwoofer side.

When LF Direct is off, the crossover frequency can be continuously adjusted in a wide range from 50 Hz to 240 Hz so that it can be adjusted according to the listening room or speakers.

Equipped with an auto power off function, the FOMA terminal automatically goes into standby mode when there is no sound for several minutes during playback. It automatically returns to ON when a signal is input.

There are 2 types of exterior variations, beach finish and silver finish.

There was also a System-11R with two pairs of SC-A11R and one set of SC-C11R and DSW-11R.

Model Rating

Method	Built-in Amplifier / 1-Way / 1-Speaker / Bass Reflex System / Floor Type / Anti-magnetic Design
<Woofer>
Units Used	For Ultra Low Band : 16 cm Cone Type
Playback frequency band	25 Hz to 240 Hz with LF Direct off
Amplifier Unit
Maximum power output	60W(Peak)
Crossover	50 Hz ~ 240 Hz (Continuously Variable)
Input impedance	Line : 50k Ω
Output terminal	Line out
Pwer	100 VAC, 50Hz/60Hz
Power consumption	38W 1.5W (standby)
<General>
External dimensions	Width 270x Height 312x Depth 333 mm
Weight	10.3kg
Attachment	1 x RCA pin cord (approx. 4m)