DENON PMA-915
¥ 33,000 (around 1988)
Commentary
Thin pre-main amplifier with simple straight configuration.
50W + 50W (6 Ω) output is achieved by adopting a large capacity power transistor in the final stage.
A tone control circuit is used.
It has Route 6 (including Phono MM) audio inputs and two speaker outputs.
Model Rating
Type | Pre-main amplifier |
Power Amplifier Unit | |
Rated Output (20 Hz ~ 20 kHz) | 37W + 37W (8 Ω) |
Maximum practical power | 50W + 50W (6 ohm, EIAJ) |
Input Sensitivity / Impedance | CD Input : 150mV/40k Ω |
Total harmonic distortion factor | 0.003% (1 kHz, 17.5W, 8 Ω) |
Cross modulation distortion factor | 0.03% (equivalent to 35W output, 8 Ω |
Dynamic Characteristics / Dynamic Power | 70W/4 Ω |
Output bandwidth | 10 Hz ~ 40 kHz (Output 17.5W, 0.1%, 8 Ω) |
Line input frequency characteristic | 5 hz ~ 150 khz + 0 -3dB (Output 1W, 8 Ω) |
Output impedance | 0.18 Ω or less |
Output terminal | Speaker : AORb : 6 ~ 16 Ω, A + B : 12 ~ 16 Ω Headphone Jack Maximum Output : 100 mW (8 Ω), 8 ~ 400 Ω Compatible |
Preamplifier Section | |
Input Sensitivity / Impedance | Phono MM : 2.5mV/47k Ω CD/CDV, Video1, Video2/Tuner, DAT/Tape1, Tape2 : 150mV/40k Ω |
Maximum output and rated output | 10 v / 150 mv (Rec. Out) |
RIAA deviation | 20 Hz to 20 kHz ± 0.5 dB |
<General> | |
Signal-to-noise ratio (Audibility Correction A, Input Short Circuit) |
Phono MM:72dB Line : 100 dB |
Tone control characteristics | Bass:100Hz+14dB |
Power consumption | 75W |
Pwer | 100 VAC, 50Hz/60Hz |
External dimensions | Width 434x Height 100x Depth 270 mm (including foot, knob, terminal, etc.) |
Weight | 5.2kg |