Audio Database

AVC-1030G
Commentary

An AV amplifier that uses a discrete amplifier in the front and center to improve the sound quality during 2 ch playback.

The two channel stereo playback of CDs has been improved by adopting a discrete configuration with the same power and response for the front and center channels and a circuit configuration equivalent to a pure amplifier.

To reduce interference between video and audio, both sections are separated from the power supply.

The Dolby Pro-Logic Decoder uses an IC jointly developed with a semiconductor manufacturer with a track record in the United States to improve SN and distortion.

In order to keep the separation of each channel of the prologic always good, it is equipped with an auto input balance which compensates for the level difference between channels in real time.

Equipped with 6-mode surround playback.
You can freely choose from 4 modes of "normal mode", "phantom mode", "wide mode" and "3-channel logic mode" according to the size of the room and the contents of the speaker system. In addition, you can also surround playback of general stereo recording sources in 2 modes of "hall" and "studio".
Since the delay time can be selected every 5 msec, the surround effect can be enhanced depending on the size of the listening room and the type of software.

A test tone generation circuit is mounted, and the level can be set according to the listening condition.

The surround preset memory function allows you to store the rear, center level, and delay time status of each surround, making it easy to set the delay time to enhance the surround effect.

FL display with large multi-function display function is adopted.

It is equipped with input / output terminals of four audio equipment systems and visual equipment Route 3.
In addition, it has a center-out connector for the center speaker and a pre-out connector for sub-woofer connection for bass enhancement.

It comes with a remote controller that can switch power ON/OFF, volume and input.

Model Rating
Type AV control amplifier
Power Amplifier Unit
Maximum Practical Power (EIAJ) Front : 80W + 80W (6 Ω)
Center : 80W (6 Ω)
Rear : 25W + 25W (6 ohm)
Frequency characteristic 10 Hz ~ 50 kHz + 0 -3dB
Output terminal Front : 6 Ω ~ 16 Ω
Center : 6 Ω ~ 16 Ω
Rear : 6 Ω ~ 16 Ω
Preamplifier Section
Input Sensitivity / Impedance 150mV/47k Ω
Tone control characteristics Bass : 100 Hz, ± 10 dB
Treble : 10 kHz ± 10 dB
Phono Input ~ Rec Out Specifications Input sensitivity / impedance : 2.5mV/47k Ω
RIAA deviation : 20 Hz to 20 kHz ± 1 dB
Signal-to-noise ratio : 76 dB (when hearing correction A input is short-circuited, 5 mV input)
Total harmonic distortion rate : 0.03% (1 kHz, 3 V)
<Video Part>
I/O Level / Impedance
Standard Video Terminal : 1Vp-p/75 Ω
S terminal : Y (luminance) signal : 1Vp-p/75 Ω
C (Color) Signal : 0.286Vp-p/75 Ω
Frequency characteristic Standard video terminal : 1 Hz to 8 MHz + 0 to 3 dB
S Terminal : 1 hz ~ 10 mhz + 0 -3dB
<General>
Power supply voltage 100 VAC, 50Hz/60Hz
Power consumption 150W
External dimensions Width 470x Height 141x Depth 421 mm
Weight 12.5kg
Included : Wireless Remote Control RC-157
BATTERY 2 UM-3 (AA)
External dimensions Width 60x Height 175x Depth 18 mm
Weight 120g (including dry batteries)