DENON AVC-1000

Commentary

6/4XP Dolby Pro Logic compatible AV amplifier.

6/4XP (Extended Power Amplifier) is adopted.
As a result, it can be used not only as a 6 chAV amplifier but also as a 4 chAV amplifier by combining with a pre-main amplifier you have.
When 6 ch is used, it consists of front 100Wx2, center 50Wx2, and rear 50Wx2. When 4 chAV amplifier is used, center 100Wx2 and rear 100Wx2 are output from AVC-1000, and front output is output from other amplifier.

It is equipped with a cinema sound equalizer and AVSE circuit aiming for easy-to-listen dialogue and powerful deep bass.
With the Cinema Sound Equalizer, it is possible to correct the sound characteristics of a movie theater or movie software recorded assuming that a center speaker is installed behind the screen for use in ordinary homes.
In addition, at the AVSE circuit, you can enjoy more powerful deep bass playback.

The Dolby Pro-Logic Surround System incorporates a directional enhancement circuit that dramatically improves the front-rear and left-right channel separation compared to conventional Dolby Surround playback.
The Dolby Pro Logic mode can be selected from four modes : a wide mode, which is suitable when the left and right speakers and the center speaker are equivalent ; a normal mode, which outputs a signal of 100 Hz or less from the left and right speakers when the center speaker is smaller than the left and right speakers ; a phantom mode, which uses a directional enhancement circuit without using the center speaker to enjoy four channel surround sound ; and a 3 ch mode, which uses no rear speaker.
It is also equipped with a surround mode so that ordinary stereo recording software can enjoy the surround effect. You can choose from hall / stadium / simulated surround.

The delay circuit uses a digital delay system.
The delay time can be adjusted from 15 msec to 30 msec for pro-logic and from 5 msec to 40 msec for hall simulated (0 msec fixed for live).

Equipped with a test tone generation circuit, fine level setting is possible.

The functions are always displayed on the monitor screen. In addition to this function, a superimpose function is installed, which is displayed on the monitor screen for approximately five seconds by operating the monitor screen or the remote control.

Equipped with a mono-out terminal for a subwoofer.

Equipped with the last function memory function.

S³Equipped with learning remote controller with function.
This remote controller is equipped with three system functions : a system remote control function, a system call function, and a system entry function. The system remote control function enables you to control DENON CD players, tuners, decks, etc. without having to learn them.
With the system call function, you can store 10 key operations in one key operation. With the system entry function, you can register the name of an input / output device as you like (up to 8 characters) and display it on the display or call it up.

In addition to the black color AVC-1000, there was the gold color AVC-1000G with side wood.

Model Rating

Type	AV control amplifier
Power Amplifier Unit
Maximum Practical Output (6 Ω, EIAJ)	Front : 100W + 100W Center : 50W + 50W Rear : 50W + 50W
Frequency characteristic	20 Hz ~ 50 kHz + 0 -3dB (output 1W, 8 Ω)
Output terminal	6 Ω ~ 16 Ω
Maximum headphone output	284 mW (8 Ω) 8 Ω ~ 400 Ω Compliant
Preamplifier Section
Input Sensitivity / Impedance	Phono MM : 2.5mV/47k Ω Line : 150mV/47k Ω
Rec Out Specifications	Phono MM SN ratio : 76 dB (at hearing compensation A, input short circuit, 5 mV input) Maximum Output / Rated Output : 8V/150mV Total harmonic distortion rate : 0.005% (1 kHz, 3 V) RIAA deviation : 20 Hz to 20 kHz ± 1.0 dB
Front Pre Out Specifications	Flat frequency characteristics : 10 Hz to 50 kHz Tone control Bass : ± 10 dB (100 Hz) Treble : ± 10 dB (10 kHz) Maximum output / rated output : 8V/1V Total harmonic distortion rate : 0.008% (1 kHz, 3 V)
<Video Part>
I/O Level / Impedance	Standard Video Terminal : 1Vp-p/75 Ω S terminal : Y (luminance) signal : 1Vp-p/75 Ω C (Color) Signal : 0.286Vp-p/75 Ω
Frequency characteristic	Standard Video Terminal : 6 hz to 6 mhz + 0 to 3 db S terminal Y signal : 6 Hz ~ 10 MHz + 0 -3dB
<General>
Power supply voltage	100 VAC, 50Hz/60Hz
Power consumption	190W
External dimensions	AVC-1000 : Width 434x Height 139x Depth 421 mm AVC-1000G : Width 470x Height 140x Depth 421 mm
Weight	AVC-1000:13.6kg AVC-1000G:15kg
Attachment : With Learning Function S3Remote Control RC-128
BATTERY	2 UM-3 (AA)
External dimensions	70 mm wide x 215 mm high x 18 mm deep
Weight	160g (including dry batteries)