TOSHIBA SA-10
¥ 42,000 (around 1960 s)
Commentary
FM/AM receiver with front-end FET.
FET is used in the front end of the FM tuner to achieve stable reception with less noise.
The SA-10 uses silicon transistors manufactured by Toshiba on the front.
Light is mounted on the dial face.
SEPP-p-OTL circuit is used for the power amplifier.
Wood cabinet is adopted.
Equipped with high / low filter and loudness control.
Equipped with an FM stereo indicator and an AFC switch for stable reception of FM broadcasts.
Ferrite antenna for AM is mounted.
Model Rating
Type | FM/AM Receiver |
Amplifier Unit | |
Total output | 50W (Music Power) 25W (Music Power IHF) |
Total harmonic distortion factor | 0.8%(20W) |
Frequency characteristic | 20 Hz to 60 kHz |
Channel separation | Phono:50dB |
Signal-to-noise ratio | Phono:66dB Aux:70dB |
Output impedance | 4 Ω ~ 16 Ω |
Damping factor | 25 (8 Ω Load) |
Input sensitivity | Phono : 5mV/50k Ω Aux : 200mV/100k Ω Tape : 500mV/200k Ω |
Recorded output | Tape (DIN) : 50mV/100k Ω |
Equalizer | NF Type, RIAA |
Tone control | Bass : + 10 to -12dB (100 Hz) Treble : + 10 to -12dB at 10 kHz |
Loudness control | + 10 dB (100 Hz), + 8 dB (10 kHz) |
Low filter | -9dB(100Hz) |
High filter | -8dB(10kHz) |
Selector switch | Phono, AM, FM, FM-ST, Tape |
<FM/AM Tuner Section> | |
Receiving frequency | FM : 76 MHz to 90 MHz AM : 530 kHz to 1,605 kHz |
Sensitivity | FM : 5 μ V AM : 10 μ V/m |
Image ratio | FM:40dB AM:40dB |
Signal-to-noise ratio | FM:55dB AM:50dB |
Selectivity | FM:40dB AM:20dB |
Bandwidth | FM:350kHz AM:6kHz |
Frequency characteristic | FM : 30 Hz to 18 kHz AM : 50 Hz to 6 kHz |
<FM-MPX Part> | |
Channel separation | 35dB |
Signal-to-noise ratio | 50dB |
Total harmonic distortion factor | 0.8% |
Frequency characteristic | 30 Hz to 15 kHz |
<General> | |
Semiconductor used | Transistor : 24 FET : 1 Diode : 15 pcs Thermistor : 4 pcs |
External dimensions | Width 470x Height 166x Depth 360 mm |
Weight | 9.5kg |